iottie One Touch Wireless 2 Dash and Windshield Mount User Manual

: October 30, 2023
: iOttie

Table of Contents

Getting Started
At a Glance
Qi Alignment Guide
Adjusting the Mount
Connecting to Power
Installation
Using the Easy One Touch Mechanism
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Easy One Touch Wireless 2

Easy One Touch
Wireless 2
CD Slot + Air Vent Mount
User Manual

Getting Started

For optimal mounting and charging, please follow the detailed instructions within this manual when using the Easy One Touch Wireless 2 Charging Mount. iOttie is not liable for possible damages due to product misuse.

Critical Information
Compatibility
The Easy One Touch Wireless 2 is compatible with all Qi-enabled smartphones including Google, Apple, & Samsung devices.
(Wireless charging speed is dependent on phone make and model.)
Qi Wireless Charging in Vehicle
Use the included iOttie car charger and micro USB cable. If you use a third party car charger, make sure that it is Qualcomm Quick Charge 2.0 or above.
The Easy One Touch Wireless 2’s signal may interfere with your vehicle’s TPMS (tire pressure monitoring system). If you notice that your TPMS light turns on, reposition the mount to prevent the signals from interacting.

At a Glance

Qi Alignment Guide

The Qi receiver coil is usually located in the center area of the phone.
Check with your phone’s manufacturer for Qi coil location. Below are some examples for commonly used phones.

For optimal wireless charging, please make sure your smartphone and mount’s Qi coils are aligned.

Adjusting the Mount

Cradle knob
When switching between landscape and portrait mode, loosen the cradle knob to rotate the cradle. Tighten the knob to lock the mount in your desired position.

Foot release button
The foot can be adjusted to 3 different height settings to accommodate different phone sizes. Once setup is chosen, the foot is designed to align with the center of the side arms for optimal Qi wireless charging.

Connecting to Power

The Easy One Touch Wireless 2 is powered by a micro USB cable.
There is no on/off switch on the mount. Once it is plugged in, the mount will remain on until the vehicle is turned off.

Installation

CD Slot Mount

Attach the CD mount to the cradle. Tighten using the adjustment knob.
Put the mount into the CD slot and pull the lever to lock it into place.
Test to make sure the mount is secure. Insert bracket only if needed.

If using the bracket, make sure the arrow is pointing inward.
1. Align your smartphone in the center of the Easy One Touch trigger button. The indicator light will turn on when the phone is successfully charging.

Air Vent Mount

Attach the air vent mount to the cradle. Tighten using the adjustment knob.
Loosen the twist lock and push the mount completely onto the air vent blade.
Slowly tighten the twist lock to ensure a secure connection to the air vent blade.
Align the smartphone in the center of the Easy One Touch trigger button. The indicator light will turn on when the phone is successfully charging.

Please use caution when adjusting the twist lock on the air vent blade.

Using the Easy One Touch Mechanism

The Easy One Touch lock and release mechanism makes it simple to mount & retrieve smartphones in seconds.

Mounting

Squeeze the release bars on either side of the mount to open the locking side arms.
Press your device against the Easy One Touch trigger button. The mount’s arms will automatically close on contact for a secure hold.

Releasing
Press the release bars.
The arms will open so youkan retrieve your device.

Wireless Charger Specifications