HALO HIWSKB1BLE40AWH Multi Room Scene Keypad User Manual

HALO HIWSKB1BLE40AWH Multi Room Scene Keypad

Installation Instructions For Scene Keypad Battery Powered HIWSKB1BLE40A

ONLY USE WITH HALO HOME LIGHTING FIXTURES, CONTROLS AND ACCESSORIES.

WARNING

CHOKING HAZARD
Small parts. Not for children under 3 years.

• The danger of explosion if the battery is incorrectly replaced. Replace only with the same or equivalent type.
• The battery (battery or batteries or battery pack) shall not be exposed to excessive heat such as sunshine, fire or the like.
• Chemical Burn Hazard. Keep batteries away from children.
• This product contains a lithium battery. If a new or used lithium cell battery is swallowed or enters the body, it can cause severe internal burns and can lead to death in as little as 2 hours. Always completely secure the battery compartment. If the battery compartment does not close securely, stop using the product, remove the batteries, and keep it away from children. If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention.
• The cells shall be disposed of properly, including keeping them away from children.
• Even used cells may cause injury.

In-Wall Anywhere Mount

• Determine a convenient wall area. Follow all local applicable codes for wall height.
• Confirm that there are no studs or other in-wall obstructions.
• Measure and cut out area for low voltage wall box or bracket (sold separately).
• Install the wall box/bracket as per the chosen product’s instructions.

Battery Installation

• Install battery… Mount HALO Home Scene Keypad using the provided screws into the wall box/bracket…faceplate (sold separately)…then refer to the HALO Home app pairing instructions at www.cooperlighting.com

Factory Reset
Press the 1 button 4 times, then the power button 4 times, then the 1 button 4 times. The LED indicator will stay on for 5 seconds and then blink for 30 seconds on a successful reset.

FCC STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, according to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment must be installed and operated per the provided instructions and the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

CAUTION!
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Bluetooth
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Cooper Lighting Solutions is under license. Other trademarks and trade names are those of their respective owners.

Industry Canada
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions:

1. This device may not cause interference; and
2. This device must accept any interference, including interference that may cause undesired operation of the device.

The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS-102 RF exposure, users can obtain Canadian information on RF exposure and compliance.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment should be installed and operated with a minimum distance of 20 centimetres between the radiator and your body.

5-Year Limited Warranty

THE FOLLOWING WARRANTY IS EXCLUSIVE AND IN PLACE OF ALL OTHER WARRANTIES, WHETHER EXPRESS, IMPLIED OR STATUTORY INCLUDING, BUT NOT LIMITED TO, ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR ANY PARTICULAR PURPOSE.
Cooper Lighting Solutions warrants to customers that, for five years from the date of purchase, Cooper Lighting Solutions products will be free from defects in materials and workmanship. The obligation of Cooper Lighting Solutions under this warranty is expressly limited to the provision of replacement products. This warranty is extended only to the original purchaser of the product. A purchaser’s receipt or other proof of date of original purchase is acceptable to Cooper Lighting Solutions. This is required before warranty performance shall be rendered. This warranty does not apply to Cooper Lighting Solutions products that have been altered or repaired that have been subjected to neglect, abuse, misuse or accident (including shipping damages). This warranty does not apply to products not manufactured by Cooper Lighting Solutions that have been supplied, installed, and/or used in conjunction with Cooper Lighting Solutions products. Damage to the product caused by replacement bulbs or corrosion or discolouration of brass components is not covered by this warranty.

LIMITATION OF LIABILITY:
IN NO EVENT SHALL COOPER LIGHTING SOLUTIONS BE LIABLE FOR SPECIAL, INDIRECT, INCIDENTAL, OR CONSEQUENTIAL DAMAGES (REGARDLESS OF THE FORM OF ACTION, WHETHER IN CONTRACT, STRICT LIABILITY, OR IN TORT INCLUDING NEGLIGENCE), NOR FOR LOST PROFITS; NOR SHALL THE LIABILITY OF COOPER LIGHTING SOLUTIONS FOR ANY CLAIMS OR DAMAGE ARISING OUT OF OR CONNECTED WITH THESE TERMS OR THE MANUFACTURE, SALE, DELIVERY, USE, MAINTENANCE, REPAIR OR MODIFICATION OF COOPER LIGHTING SOLUTIONS PRODUCTS, OR SUPPLY OF ANY REPLACEMENT PARTS THEREFORE, EXCEED THE PURCHASE PRICE OF COOPER LIGHTING SOLUTIONS PRODUCTS GIVING RISE TO A CLAIM. NO LABOR CHARGES WILL BE ACCEPTED TO REMOVE OR INSTALL FIXTURES.

To obtain warranty service, please contact Cooper Lighting Solutions, at 1-800-334-6871, press option 2 for Customer Service, or via e-mail at ConsumerProducts@cooperlighting.com and include the following information:

• Name, address and telephone number
• Date and place of purchase
• Catalog and quantity purchase
• Detailed description of problem

All returned products must be accompanied by a Return Goods Authorization Number issued by the Company and must be returned freight prepaid. Any product received without a Return Goods Authorization Number from the Company will be refused. Cooper Lighting Solutions is not responsible for merchandise damaged in transit. Repaired or replaced products shall be subject to the terms of this warranty and are inspected when packed. Evident or concealed damage that is made in transit should be reported at once to the carrier making the delivery and a claim filed with them. Reproductions of this document without prior written approval of Cooper Lighting Solutions are strictly prohibited. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.

Cooper Lighting Solutions
1121 Highway 74 South Peachtree City, GA 30269

• P:770-486-4800
• www.cooperlighting.com
• 2020 Cooper Lighting Solutions All Rights Reserved Printed in China
• Cooper Lighting Solutions is a registered trademark. All trademarks are the property of their respective owners.

Specifications

• Model: IL517021EN
• Mounting Type: In-Wall Anywhere Mount
• Power Source : Battery
• Compatibility : HALO Home Scene Keypad

Frequently Asked Questions (FAQ)

Q: What should I do if the device is not pairing with the HALO Home app?
A: If you are facing issues with pairing, try resetting the device by following the factory reset instructions provided in the manual. Ensure that you are following the correct steps and are within range of a stable Wi-Fi connection.

Q: How do I know if the battery needs to be replaced?
A: If you notice a decrease in performance or if the device fails to power on, it may be time to replace the battery. Follow the instructions in the manual for battery replacement to ensure safe and proper functioning of the device.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>