KUZCO EG26724 LED Exterior Garden Instruction Manual
- June 3, 2024
- KUZCO
Table of Contents
EG26724 LED Exterior Garden
Instruction Manual
START FROM HERE
- Make sure the POWER is COMPLETELY OFF
- Have your fixture installed by a qualified licensed electrician
- Prepare everything in a clear area
- Wear gloves at all times during this installation
- Read instructions carefully before you start the assembly
- Keep this installation sheet for future reference
Technical Support: 1-855-855-8926
Please Note:
-
This Kuzco LED fixture comes with pre-wired LED module(s)
-
Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary
contact with the module could cause permanent damage -
12V input with Outdoor Rated Low Voltage Transformer (Transformer supplied by others)
-
Non-Dimming
-
For typical ground stake mounting
-
Luminaires shall not be installed within 10 feet of the pool, spa, or fountain
-
Remove the fixture from its original package
-
Run fixture wire (1b) from fixture (1a) through the mounting hole on top of the ground stake (3a)
-
Run transformer wire (provided by others) to the location of the intended install
Note: the low-voltage wires are intended for shallow burial – less than 6 inches -
Attach fixture thread (1d) (Note: fixture thread (1d) is 1/2-14 NPT) to ground stake (3a) by threading clockwise until it fits snuggly
-
Fill outdoor-rated wire nuts (2a) with silicone sealant (not provided) . Cut and strip fixture wires (1b) and connect to transformer wire using outdoor rated wire nuts (2a) provided (Illustration 1)
Note: for multiple low-voltage garden light installations daisy-chain low-voltage wire to each fixture from a 12V transformer -
Place stake (3a) in the desired position and insert it into the ground until the flange of the stake is flush with the ground
19054 28th Avenue Surrey, BC Canada V3Z 6M3
T: 604 538 7162
TF: 1-855 85 KUZCO
F: 604 538 7196
W: kuzcolighting.com
20210422
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>