AViANCE HD28999 Ceiling Hanging Light Instruction Manual
- June 1, 2024
- AVIANCE
Table of Contents
AViANCE HD28999 Ceiling Hanging Light
Product Specifications
- Model: HD28999
- Fixture Wires: Black or Smooth, White or Ribbed, Bare Copper (Ground)
- House Wires: Black (Hot), White (Neutral), Green or Bare Copper (Ground)
- Junction Box: Not included
- Manufacturer: AVIANCE
Product Usage Instructions
Assembling & Installation:
The drawing provided may not be an exact match, but the installation instructions apply to the product.
- Shut off the power at the circuit breaker box.
- Remove the old fixture and all connections.
- Assemble the fixture according to the provided diagram (Fig.1).
- Connect the fixture wires to the corresponding house wires:
- Black or Smooth to Black (Hot)
- White or Ribbed to White (Neutral)
- Bare Copper to Green or Bare Copper (Ground)
- Securely mount the fixture in place.
- Turn on the power at the circuit breaker box.
- Test the fixture to ensure proper functionality.
For Customer Service:
If you need assistance with parts or assembly, please contact customer service at info@aviancelighting.net. Frequently Asked Questions
Q: Is the junction box included with the product?
A: No, the junction box is not included. You will need to provide your own junction box for installation.
Q: What should I do if the fixture does not work after installation?
A: Double-check all connections and ensure that the power is properly restored. If issues persist, contact customer service for assistance.
The drawing shown may not exactly match the product enclosed. However, the installation instructions do apply to this product
- WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
- ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.
ASSEMBLING
ASSEMBLING THE FIXTURE (Fig.1)
- Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box. Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation.
- Slide the electrical wires through the tubes (F)/(E)/(D) and canopy(B). Raise the tube (F) to top coupling of fixture body (G), by turning it clockwise until tight. Raise the tubes (E)/(D) and canopy (B) to the screw pipe in order, then by turning it clockwise until tight.
- Raise the glass shade (H) and cover (I) to the socket holder, and lock it securely with ring (J) until snug.
- Thread the two mounting screws into the pre-drilled holes in the Mounting plate spaced the same distance apart as the holes in the canopy (B).
- Attach the mounting plate to the Junction Box with the two Junction Box screws as shown. The side of the mounting plate marked “GND” must face to out. The junction box is not included.
- While holding the fixture body towards the ceiling, connect the electrical wires as Shown in Fig.2, making sure that all wire nuts are secured. You may have to wrap the connections with electrical tape. If your outlet has a ground wire (green or bare copper), connect the fixture ground wire to it. Otherwise, connect the fixture’s ground wire directly to the Single bar with the green screw provided. After wires are connected, tuck them carefully inside the Junction Box.
- Raise the canopy (B) onto the Junction box, aligning screws on the mounting plate with mounting holes in the canopy and lock it securely with the ball nuts (C).
- Install the light bulbs (Not included) in accordance with the fixture’s specifications.
NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE! Your installation is now complete.
Return power to the junction box and test the fixture.
Thank you for purchasing an AVIANCE product. Need assistance with parts or assembly? Please email customer service at:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>