Fiilex Q8 COLOR LR Light User Guide

Fiilex Q8 COLOR LR Light User Guide

Safety Instructions

• DO NOT disassemble Q8 Color. This will void the warranty.
• DO NOT install Q8 Color in damp or wet locations.
• DO NOT obstruct the fixture’s air vents.
• Use safety cable (not included) when rigging Q8 Color overhead.
• Only use Fiilex approved power supply and accessories. Failure to do so may damage the fixture.
• Shields, lenses or ultraviolet screens shall be changed if they have become visibly damaged to such an extent that their effectiveness is impaired, for example by cracks or deep scratches.
• The lamp shall be changed if it has become damaged or thermally deformed.
• The luminaire is intended for professional use only.
• Do not look into the light source with any instrument that could concentrate the light output: this includes magnifiers, binoculars, telescopes, etc.
• This fixture corresponds to Risk Group 1 according to EN 62471 under normal operation condition, which considers all photo biological risks. It corresponds to Risk Group 1 according to EN 62778 under those conditions, which considers risk from blue light only.
• The light output can potentially cause eye injury if stared at for a prolonged period of time

Parts Diagram

1. Vent Holes

2. Water Repellent Fabric

3. Yoke Bolt

4. Tilt Lock Lever

5. Beam Adjustment Knob (Spot to Flood)

6. Yoke

7. Junior Pin Receiver

8. Mount Tightening Knob

9. Latch

10. Fresnel Lens

11. Fresnel Lens Holder

12. Power Supply Unit (PSU)
    

13. Antenna

14. USB Type-C Port (For updating firmware)

15. USB Type-A Port (5V/1A Power)

16. Wireless Signal Indicator

17. Unlink Button (For disconnecting the wireless signal)

18. Intensity Control Knob

19. LAN Port

20. DMX Input (XLR-Male 5-pin)

21. Dual Locking V-Mount

22. DC Input Port

23. CCT/HUE Knob

24. OLED Display

25. Navigation Pad

26. GN/SAT Knob

27. Handles

28. ON/OFF Switch

29. DMX Output (XLR-Female 5-pin)

Fixture Operation

• Mode Selection
  Use Navigation Pad to enter MODES menu, then navigate to select the desired mode.
  

• Fixture Control

1. Manual / Local :
   Use Intensity Control Knob or the Navigation Pad to control the parameters.
   

2. For CCT modes and HSI modes, use either CCT/HUE
   Knob and GN/SAT Knob or the Navigation Pad

3. DMX / RDM / Ethernet (ArtNet / sACN) :
   Display shows DMX connection status, NO DMX or
   DMX OK.

Settings

Use Navigation Pad to enter and edit SETTINGS. Navigate to the right to access additional settings

Fan speed options****

Dimming options
Sharp| Best for flash and strobe effects.
Smooth| Best for gradual fades.

Ethernet
Modify ArtNet and sACN settings of the fixture.

Info
View current fixture firmware versions and fixture temperature

1689 Regatta Blvd. Richmond, CA: 94804 | 510-620-5155 | fiilex@fiilex.com
www.fiilex.com

References

• Fiilex LED Lights

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>