tp-link TL-SF1005D 10-100 Mbps Desktop Switch Installation Guide
- June 9, 2024
- tp-link
Table of Contents
tp-link TL-SF1005D 10-100 Mbps Desktop Switch
Connection
FAQ
-
Q1. The Power LED is not lit.
The Power LED should be lit when the power system is working normally. If the Power LED is not lit, please check as follows: -
A1: Make sure the power cord is connected to the switch with power source properly.
-
A2: Make sure the voltage of the power supply meets the requirements of the input voltage of the switch.
-
A3: Make sure the power source is ON.
-
Q2. The Link/Act LED is not lit when a device is connected to the corresponding port.
It is recommended that you check the following items: -
A1: Make sure that the cable connectors are firmly plugged into the switch and the device.
-
A2: Make sure the connected device is turned on and working well.
-
A3: The cable must be less than 100 meters long (328 feet).
To ask questions, find answers, and communicate with TP-Link users or
engineers, please visithttps://community.tp-link.com to join TP-Link
Community.
For technical support and other information, please visit https://www.tp-
link.com/support, or simply scan the QR code.
If you have any suggestions or needs on the product guides, welcome to email
[email protected].
EU declaration of conformity
TP-Link hereby declares that the device is in compliance with the essential
requirements and other relevant provisions of directives 2014/30/EU,
2014/35/EU, 2009/125/EC, 2011/65/EU and (EU)2015/863.
The original EU declaration of conformity may be found at https://www.tp-
link.com/en/ce.
Specifications
General Specifications
Environmental and Physical Specifications
- Operating Temperature 0˚C to 40˚C (32˚F to 104˚F)
- Operating Humidity 10% to 90%RH non-condensing
- Storage Humidity 5% to 90%RH non-condensing
Installation Guide
10/100 Mbps Desktop Switch
Safety Information
- Keep the device away from water, fire, humidity or hot environments.
- Do not attempt to disassemble, repair, or modify the device. If you need service, please contact us.
- Do not use damaged charger or USB cable to charge the device.
- Do not use any other chargers than those recommended.
- Adapter shall be installed near the equipment and shall be easily accessible.
- Place the device with its bottom surface downward.
- Use only power supplies which are provided by manufacturer and in the origin packing of this product. If you have any questions, please dont hesitate to contact us.
LED Explanation
Power
- On: Power on
- Off: Power off
Link/Act
- On: Link present but no activity
- Flashing: Transmitting/receiving data
- Off: No link