signify NCFG9xx NatureConnect Link 3D Printed Lighting Installation Guide
- June 1, 2024
- signify
Table of Contents
signify NCFG9xx NatureConnect Link 3D Printed Lighting
WHAT IN THE BOX
Dimensions
Mount to surface above
Power Wiring
Open the cover
Luminaire & Control Wiring
Set DIP switch for power supply of DALI_IN
Set the rotary switches for the time zone according to the Time zone table
Example: setting the
time zone for Eastern US
INFORMATION
Power on
Test the connection with the luminaires by pressing the service button
Time configuration
- LED on → Time acquired from NTP server
- LED off — Download the NatureConnect link configuration app to configure the time
- LED blinking: www.signify.com/natureconnect
Close the cover and enclosure
Additional notes
- For more information on Interact Pro visit: www.interact-lighting.com/interactproscalablesystem
- For reset to factory default settings: long press (10 seconds) on the Service button
- Recommended to use a firewall.
- Recommended to change the password at first use.
LED Legend
- LED 1 (Red) Power status:
- OFF when no power to the device
- ON when power is on
- LED 2 (Blue) Network status (only after booting finished):
- OFF when no network link
- BLINKING when network link but no IP
- ON when the network link is available and the IP address assigned
- LED 3 (Yellow) Internet/NTP status (only after booting finished):
- OFF when no internet
- BLINKING when the internet is available but NTP is not available
- ON when the internet and NTP are available
Service Tag: 12.910505103474
2023/08/30 – 443582801432
© Signify Holding. All rights reserved
Data subject to change without notice
www.signify.com/natureconnect
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>