73200 Lindy Bluetooth Headphones User Manual

73200 Lindy Bluetooth Headphones

Introduction

Thank you for purchasing the LH500XW by Lindy. These wireless noise cancelling headphones have been developed to deliver superb quality Hi-Fi sound using advanced aptX® technology without the distraction of annoying background noise.

Product Contents

• LH500XW Headphones
• 3.5mm audio cable 1.5m
• 1/’l” stereo-plug adapter
• Dual-plug flight adapter
• Micro USB charging cable 80cm
• Hard carry EVA case with mesh pouch
• User manual

Features and Benefits

Overview

Left
USB Socket (for charging) Volume Down/ Previous Song (Wireless only)
Multi-Function Button: On/Off, Pairing, Make/Answer/ End/Reject Call (Wireless only) Volume Up/ Next Song (Wireless only) Microphone 3.5mm Audio Jack Battery Indicator

Right
Volume Control Dial (Wireless,
Noise Cancelling or Wired)
Noise Cancelling On/Off Switch
Noise Cancelling Indicator

Safety

• Check the volume level before placing the headphones over your ears
• Do not listen to the headphones at high volume for excessive periods as this may damage your hearing
• Discontinue use if you experience any discomfort or irritation from using the headphones
• These headphones must not be worn whilst driving a motor vehicle

Charging the Battery

When the battery is low the LED (7) will flash red and an audio prompt [five beeps] will be heard through the headphones. If you’re using a compatible iOS device you can also see the status of the headphones battery on your device.
Plug the supplied USB charging cable in to the charging port on the headphones (1).
Plug the other end of the USB charging cable into the corresponding port on either a USB mains power supply or a PC.
The LED indicator will light up red.
Charging from empty will take approximately 3 hours.
When the battery is fully charged, the LED indicator will switch from red to off.

Important! Make sure that the LHSOOXW are fully charged for at least ‘I hours prior to initial use.

Operation

The LHSOOXW can be used in a number of different configurations to suit your needs; Wired, Wireless, Noise Cancelling and Passive. For optimum audio performance we recommend using the headphones with Noise Cancelling activated.

Noise Cancelling

Adjust The volume of the LHSOOXW using the Volume Control Dial (8) to ensure the volume is not too high.
Switch on the Noise Cancelling feature by sliding the On/Off Switch (9) to On, the Noise Cancelling Indicator (10) will illuminate Blue After you turn the Noise Cancelling feature on you may hear a slight hissing noise, this is normal and will cease after a few seconds.

When using the Noise Cancelling feature, if the battery level becomes low the Noise Cancelling Indicator will become dim. If you continue to use the Noise Cancelling feature the battery will eventually drain, if you are using a wired connection you may still continue to use the headphones.

Pairing

Switch on the Wireless function by pressing and holding the Multi-Function Button (3). If no previously paired device is found within range, the LHSOOXW will automatically go into pairing mode and the LED Indicator will alternately flash Green and Red.
Enable the Bluetooth function on your mobile phone or tablet.
Navigate to the Bluetooth menu of your device and scan/search for new devices.
When LHSOOXW is found select it and follow the on screen prompts. If you are prompted for a passkey or pin-code, please use 0000.
You will see a notification on your portable device confirming that pairing and connection is complete.

Music Playback

Play/Pause Music| Press down the Multi-Function Button once to start playing music and press it again to
pause your music.
---|---
Play/Pause Music| Press the Music/Volume Forward Control button to play the next song. To play the
previous song, Press the Music/Volume Backward Control button.
Adjust Volume| Press and hold the Music/Volume Forward control button to increase the volume. To  reduce the volume, Press and hold the Music/Volume Backward Control button.
In addition the volume can be adjusted using the Volume Control Dial (8).

Call Related Functions

status
Swap calls| Press the Multi-Function Button for 3 seconds

Voice Dialling

The LHSOOXW can be used for voice dialling if this feature is supported on your mobile phone. Please refer to your mobile phone’s manual for more information. To use the voice dialling feature, press and hold the multifunction button and wait for the voice prompt before saying the name of the contact you want to call.

Technical Specification

• Bluetooth I.J.1
• Supports A2DP/HFP/HSP/AVRCP profiles
• aptX® Bluetooth HD audio technology – CSR 861.J5 Chipset
• Battery Life:
  • Up to 15 Hours Wireless Only
  • Up to 30 Hours Noise Cancelling Only
  • Up to 12 Hours Wireless & Noise Cancelling
• Charging Time Up to 3 Hours
• Noise Cancellation Rate: 85%
• Built in microphone for hands free calling
• Answer, Reject, End, Volume+/-, Track+/- & Play/Pause Control
• Dynamic Driver Diameter: l.lOmm Neodymium
• Range: up to 15m [open space)
• Frequency Response: 20Hz-20kHz
• Impedance: 32±15% Ohm
• Sensitivity (S.P.L.): 85db±3db SPL/ 1kHz [OdB SPL=20μPa)
• Nominal THO: >0.2%

Declaration of Conformity

We, LINDY Electronics LTD, hereby declare that the product(s)
LINDY Bluetooth Headphones Grey, Black No. 73200, 73201 conforms to with the requirements of the following UK Legislation and EU Directives:
Electromagnetic Compatibility Regulations 2016 / EU Directive 2014/30/EU
The Electrical Equipment (Safety) Regulations 1994 / EU Directive 2014/35/EU
The Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic Equipment Regulations 2012 / EU Directives 2011/65/EU, 2015/863/EU amendment Annex II, Article 13 (RoHS II)
The following standards were used to evaluate the product:

ETSI EN 300 328 V2.2.2 (2019-07)
ETSI EN 301 489-1 V2.2.3 (2019-11)
ETSI EN 301 489-17 V2.3.4 (2020-09)
BS EN 62368 -1:2014/A11:2017
BS EN 50332-2 :2013
BS EN 62479: 2010
BS EN 50663: 2017
BS EN IEC 63000 :2018

Date: 13 October 2022

Signature

Name: Darren N. Casey
Position: Managing Director, LINDY Electronics LTD Lindy Supplier Office Reference: 720600 19012021 Issue 12

LINDY Electronics Limited

Sadler Forster Way I Teesside Industrial Estate I Thornaby, Stockton -on- Tees I TS17 9JV. England
General T +q 16£{2 75Ll000 I F +l.Jl.J 16Ll2 75LI031 sales@lindy.co.uk

Accounts T •Lll.l 16l.l2 75Ll035 I F +l{Ll 16Ll2 75£{031 I accounts@lindy.co.uk

Co. Reg No. 02132710 (Registered office as above) I Vat Reg No. GB l.172 0100 00

EU – CE Declaration of Conformity

LINDY Bluetooth Headphones/ Bluetooth Kopfhoerer LH500XW (EU), Grey, Black No.: 73200, 73201

EU Directive 2014/30/EU (EMV / EMC)
EU Directive 2014/35/EU (Niederspannungsrichtlinie / LVD)
EU Directives 2011/65/EU, 2015/863/EU Amendment Annex II, Article 13 (RoHS II)
ETSI EN 300 328 V2.2.2 (2019-07)
ETSI EN 301 489-1 V2.2.3 (2019-11)
ETSI EN 301 489-17 V.3.2.4 (2020-09)
EN 62368-1:2014/A11:2017
EN 50332-2: 2013
EN 62479: 2010
EN 50663: 2017
EN IEC 63000: 2018

Dr. Rainer Bachmann Head of Global Product Compliance Mannheim, 12.10.2022

Ref. LINDY S-Office: 720600 19012021

FCC Certification

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
You are cautioned that changes or modification not expressly approved by the party responsible for compliance could void your authority to operate the equipment.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

WEEE [Wasta of Electrical and Electronic Equipment], Recycling of Electronic Products Europa, United Kingdom
In 2006 the European Union introduced regulations (WEEE] for the collection and recycling of all waste electrical and electronic equipment. It is no longer allowable to simply throw away electrical and electronic equipment. Instead, these products must enter the recycling process. Each individual EU member state, as well as the UK, has implemented the WEEE regulations into national law in slightly different ways. Please follow your national law when you want to dispose of any electrical or electronic products. More details can be obtained from your national WEEE recycling agency .

The following batteries or accumulators are included in this electrical appliance

Battery Quantity and Type

|

Chemical System

---|---

Internal Battery 700mAh

|

Lithium Polymer

The (rechargeable] battery cannot be removed from this device. Make sure it is completely drained before you hand the device to your collection system for waste electronic equipment.

Customer Support

Manufacturer (EU):
Lindy-Elektronik GmbH
Markircher Str. 20
68229 Mannheim Germany
T +I.JS 621 I.J70050  info@Lindy.de
Manufacturer (UK):
Lindy Electronics Ltd.
Sadler Forster Way
Stockton- on -Tees
TS17 9JY, England
T +I.JI.J 161.J2 751.J000  sales@Lindy.co.uk

Lindy No. 73200, 73201 2nd Edition January 2023 Lindy.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>