KUZCO VL19931 LED Vanity Light Installation Guide
- June 4, 2024
- KUZCO
Table of Contents
INSTALLATION SHEET
VL19931
LED Vanity Light
START FROM HERE
- Make sure POWER is COMPLETELY OFF at the fuse box
- Have your fixture installed by a qualified licensed electrician
- Prepare everything in a clear area
- Wear gloves at all times during this installation
- Read instructions carefully before you start assembly
- Keep this installation sheet for future reference
Please Note:
- This Kuzco fixture comes with pre-wired LED module(s)
- Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary contact with the module could cause permanent damage
- Use ELV (Electronic Low Voltage) or TRIAC type of dimmer for dimming application
- 120V input voltage
Technical Support: 1-855-855-8926
- Remove the fixture from its original package
- Separate mounting plate (1c) from the canopy (2a) by removing canopy screws (2b)
- Attach mounting plate (1c) to electrical junction box (1a) using junction box screws (1e) provided in hardware package
- Make proper electrical connections (black to hot “L”, white to neutral “N”, ground to “GND”) with wire nuts (1b) provided in the hardware package and then place driver (4a) inside the canopy (2a)
- Attach canopy (2a) to mounting plate (1c) with canopy screws (2b)
19054 28th Avenue Surrey, BC Canada V3Z 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W:kuzcolighting.com
20210527
Documents / Resources
|
KUZCO VL19931 LED Vanity
Light
[pdf] Installation Guide
VL19931 LED Vanity Light, VL19931, LED Vanity Light, Vanity Light, LED Light,
Light
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>