NIGHTSTICK XPP-5420B IS Permissible Flashlight Instruction Manual
- June 17, 2024
- NIGHTSTICK
Table of Contents
NIGHTSTICK XPP-5420B IS Permissible Flashlight
Product Information
Specifications
- Model : XPP-5420B/G/BA/GA
- Manufacturer: Bayco Products, Inc.
- Address: 640 S. Sanden Blvd. Wylie, TX 75098
- Approved for use with three AA Duracell Type PC1500, Energizer Type EN91, and Energizer Type L91 batteries
- Tested for intrinsic safety in methane-air mixtures
- Class I Div 1 Grps A-D T3, Class II & III Div 1 Groups E-G T135C Ex ia op is IIC T3 Ga
- Conforms to ANSI/UL STD 913, ANSI/UL 60079-0, CAN/CSA STD C22.2 No 157
Product Usage Instructions
Warnings:
- Use only the approved non-rechargeable batteries listed in the manual.
- Do NOT attempt to use rechargeable AA batteries with this light.
- To prevent ignition of a hazardous atmosphere, do not open the lens bezel in the hazardous environment. This task must ONLY be performed in an area known to be non-hazardous.
Battery Replacement:
- Replace the batteries in fresh air only.
- Replace all batteries at the same time.
- Do not mix batteries from different manufacturers or of different types.
- Energizer Lithium (Type L91) batteries are to be replaced by a qualified technician only.
Maintenance:
The Model Nightstick 5420 must not be opened in areas where permissibility is required. Contact a qualified technician for any maintenance needs.
FAQ
- Q: Can I use rechargeable AA batteries with this flashlight?
- A : No, only use the approved non-rechargeable batteries listed in the manual for safe operation.
- Q: How should I replace the batteries?
- A: Replace the batteries in a well-ventilated area, ensuring all batteries are replaced at the same time. Do not mix batteries from different manufacturers or types.
THE XPP-5420B/G/BA/GA IS APPROVED FOR USE
WARNINGS – INTRINSICALLY SAFE
- Warning : Use only the approved non-rechargeable batteries listed below.
- Warning : Do NOT attempt to use rechargeable AA batteries with this light.
- Warning : To prevent ignition of a hazardous atmosphere, do not open the lens bezel in the hazardous environment. This task must ONLY be performed in an area known to be non-hazardous.
- Warning : When exchanging batteries, use only Duracell PC1500, Energizer EN91 or Energizer L91 batteries.
- Warning : To prevent ignition of a hazardous atmosphere, the AA batteries must only be exchanged in an area known to be non-hazardous.
- Warning : To reduce the risk of explosion, do not mix new non-rechargeable batteries with used non-rechargeable batteries, or mix non-rechargeable batteries from different manufacturers.
- Warning : Substitution of components may impair intrinsic safety
SPECIAL INSTRUCTIONS FOR INTRINSIC SAFETY
For personal safety, always confirm the rating of any known hazardous or potentially hazardous location where the light is to be used.
- WARNING : In order to maintain the XPP-5420’s Intrinsically Safe rating, the only AA batteries certified for use with this light are the Duracell PC1500, Energizer EN91 or Energizer L91 batteries.
- Do not attempt to use any other brand or model of AA batteries with this light.
- Do not attempt to use any type of rechargeable AA batteries with this light.
- Warning: To prevent ignition of a hazardous atmosphere, do not remove the lens bezel or the reflector/battery carrier in the hazardous environment. This task must ONLY be done in an area known to be non-hazardous.
- Loosen the locking screw located on the side of the lens cap. NOTE: Do NOT attempt to completely remove the locking screw. Doing so is not necessary and may damage the threads. The screw simply needs to be loosened enough to allow the lens bezel to unscrew.
- Unscrew the lens bezel from the housing in a counter-clockwise direction.
- Turn the light upside down and carefully shake the light in order to remove the reflector/ battery carrier. Allow the reflector/battery carrier to slide into your hand. WARNING: DoNOT touch the reflector surface with your finger. Doing so may damage the reflector surface.
- Using 3 – AA Duracell PC1500, Energizer EN91 or Energizer L91 batteries (make sure that all 3 batteries are of the same model), install the batteries in the carrier paying close attention to the markings on the battery carrier for proper battery terminal polarity alignment.
- Align the reflector/battery carrier so that the switches on the carrier are aligned with the switches on the housing. Carefully insert the reflector/battery carrier back into the flashlight housing until it is fully seated in the housing. WARNING: Be careful to not touch the reflector surface with your finger. Doing so may damage the reflector surface.
- Replace the lens bezel by screwing it onto the housing in a clockwise direction.
- Tighten the locking screw.
CAUTION : Do NOT over-tighten. Doing so may damage the threads and impact the light’s intrinsic safety.
OPERATION
MOMENTARY FLASHLIGHT MODE
THE XPP-5420 HAS TWO SEPARATE LIGHTING MODES:
Lightly press the body switch for momentary operation. Release the switch to turn the light off.
CONSTANT-ON FLASHLIGHT MODE
Press the body switch until it clicks and then release for constant-on mode. Press and release the body switch again to turn the light off
WARRANTY
LIMITED LIFETIME WARRANTY
Bayco Products, Inc. warrants this product to be free from defects in workmanship and materials for the original purchaser’s lifetime. The Limited Lifetime Warranty includes the LEDs, housing and lenses. Rechargeable batteries, chargers, switches, electronics, and included accessories are warranted for a period of two years with proof of purchase. Normal wear and failures which are caused by accidents, misuse, abuse, faulty installation and lightning damage are excluded.
We will repair or replace this product should we determine it to be defective. This is the only warranty, expressed or implied, including any warranty of merchantability or fitness for a particular purpose.
For a complete copy of the warranty, go to www.baycoproducts.com/bayco- productsupport/warranties. Retain your receipt for proof of purchase.
EU / UK Declaration of Conformity
We hereby declare that the product identified above meets the requirements of the Directives listed below. Therefore, they qualify for free movement within markets comprising the European Union (EU), the European Economic Area (EEA) and the United Kingdom (UK). This declaration is issued under the sole responsibility of the manufacturer.
The following EU-harmonized, UK-designated standards and technical
specifications have been applied and evaluated by: 
Bayco Products, Inc.
- 640 South Sanden Blvd.
- Wylie, TX 75098
- 1-800-233-2155
- 1-469-326-9400
- www.nightstick.com
- INS-XPP-5420B/G/BA/GA-DL-23
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>