signify LyteProfile LED Gen 3 Round Downlights User Manual
- June 17, 2024
- signify
Table of Contents
Downlighting
LyteProfile LED Gen 3
442295716403
LyteProfile LED Gen 3 Round Downlights
Read and understand these instructions Before installing luminaire
(fixture).
This luminaireis intended for installation in accordance with the National
Electrical Code and local regulations. To assure full compliance with local
codes and regulations, check with your local electrical inspector before
installation.
To prevent electrical shock, turn off electricity at fuse box before
proceeding. Allow fixture to cool before handling.
Installation for LyteProfile & EasyLyte Light Engine Trims:
- P4RDL_ series
- P6RDL_ series
- P4RSL_ series
- P6RSL_ series
Caution (RISK OF FIRE)
Use only with LED light engines and reflector
Trims provided by Philips Lightolier. Use of other manufacturers trims may
void the Underwriters Laboratories listening and could constitute a fire
hazard.
Instructions for all applications
Step 1
Set Trim Springs to the correct position for the ceiling thickness.
Adjustment Ladders can be positioned every ¼” to fit various ceiling heights.
To adjust, gently disengage shim on trim spring, slide spring to appropriate
ladder setting, and allow to click into place. See Fig. A
Step 2
Feed Driver from Light Engine through the aperature hole in the ceiling and
snap into J-Box. Squeeze the two Trim Springs upward while pushing the Trim
Reflector up into the ceiling cutout. See Figs.B1 & B2. Note: Trim can be
removed by grasping reflector flange and pulling straight down.
NOTE: This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to part 14 of the FCC Rules. Theses
limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
© 2018 Philips Lighting Holding B.V. All rights reserved. Philips reserves the
right to make changes in specifications and/or to discontinue any product at
any time without notice or obligation and will not be liable for any
consequences resulting from the use of this publication.
Philips.com/luminaires
© 2021 Signify Holding. All rights reserved. The information provided herein is subject to change, without notice. Signify does not give any representation or warranty as to the accuracy or completeness of the information included herein and shall not be liable for any action in reliance thereon. The information presented in this document is not intended as any commercial offer and does not form part of any quotation or contract, unless otherwise agreed by Signify.
Signify North America Corporation
200 Franklin Square Drive.
Somerset. NJ 08873
Telephone 855-486-2216
Signify Canada Ltd.
281 Hillmount Road.
Markham, ON, Canada L6C 2S3
Telephone 800-668-9008
All trademarks are owned by Signify Holding or their respective owners.
www.brandwebaddress.com