TELTONIKA TRB256 LTE Cat M1/NB IoT Smart Meter Gateway Owner’s Manual
- June 17, 2024
- teltonika
Table of Contents
TELTONIKA TRB256 LTE Cat M1/NB IoT Smart Meter Gateway
HARDWARE
FRONT VIEW
BACK VIEW
INPUT/OUTPUT 16-PIN CONNECTOR PINOUT
- D1, D2, D3 – Configurable digital Input/Output pins.
- Open collector output, max output 30 V, 300 mA or Digital input where 0-6 V is detected as logic low and 8-30 V – logic high.
- + – 9-30 VDC positive power pin
- CTS – RS232 clear data to send pin (output).
- RTS – RS232 request data to send pin (input).
- R+ – RS485 receiver positive signal pin.
- D+ – RS485 driver positive signal pin.
- – – Negative/ground power pin.
- – Ground pins for D1, D2, D3, A, RS232 and RS485.
- A – Analog input pin. Analog voltage range 0-30 V.
- TX – RS232 transmitted data (input).
- RX – RS232 received data (output).
- R- – RS485 receiver negative signal.
- D- – RS485 driver negative signal.
FEATURES
MOBILE
ETHERNET
NETWORK
SECURITY
VPN
MONITORING & MANAGEMENT
IoT PLATFORMS
FIRMWARE CUSTOMISATION
INPUT / OUTPUT
PHYSICAL SPECIFICATION
PHYSICAL INTERFACES
STANDARD PACKAGE
- TRB256 Gateway
- 16-pin terminal block
- 1 x hex key
- QSG (Quick Start Guide)
- Packaging box
Standard package contents may differ based on standard order codes.
CLASSIFICATION CODES
- HS Code: 851762
- HTS: 8517.62.00
For more information on all available packaging options – please contact us directly.
AVAILABLE VERSIONS
TRB256 SPATIAL MEASUREMENTS
MAIN MEASUREMENTS
- W x H x D dimensions for TRB256:
- Device housing*:83 x 25 x 74.2 mm
- Box: 111 x 31 x 89 mm
TOP VIEW
The figure below depicts the measurements of TRB256 and its components as seen
from the top:
RIGHT VIEW
The figure below depicts the measurements of TRB256 and its components as seen
from the right side:
FRONT VIEW
The figure below depicts the measurements of TRB256 and its components as seen
from the front panel side:
REARVIEW
The figure below depicts the measurements of TRB256 and its components as seen
from the back panel side:
MOUNTING SPACE REQUIREMENTS
The figure below depicts an approximation of the device’s dimensions when cables and antennas are attached:
DIN RAIL
The scheme below depicts protrusion measurements of an attached DIN Rail:
Copyright © 2024, TELTONIKA NETWORKS. Specifications and information given in this document are subject to change by TELTONIKA NETWORKS without prior notice.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>