NIGHTSTICK NSP-2414GXL Bayco Flashlight Instruction Manual
- June 17, 2024
- NIGHTSTICK
Table of Contents
**NIGHTSTICK NSP-2414GXL Bayco Flashlight Instruction Manual
**
INSTALLATION INSTRUCTION
We will repair or replace this product should we determine it to be defective.
This is the only warranty, expressed or implied, including any warranty of
merchantability or fitness for a particular purpose.
For a complete copy of the warranty, go to www.baycoproducts.com/nightstick-
productsupport/warranties. Retain your receipt for proof of purchase.
WARNINGS
- NOT FOR USE ABOVE HAZARDOUS LOCATIONS
- DO NOT use in explosive atmospheres, near flammable liquids, or where explosion proof lamps are required.
- DO NOT use in the proximity of vehicles or equipment when there is a risk of flammable liquids coming into contact with the flashlight.
- DO NOT expose the batteries to water or salt water, or allow the batteries to get wet.
- DO NOT store the batteries with metallic objects that may cause a short circuit.
- Immediately discontinue use of the batteries if they emit an unusual smell, feel hot, change color, change shape or appear abnormal in any way.
- Keep out of the reach of children.
INSTALLING OR CHANGING BATTERIES
- Unscrew the lens bezel.
- Remove the reflector / battery carrier.
- Install 3 AA batteries in the carrier. Please pay attention to the orientation of the batteries as indicated by the “+” and “-“ markings on the inside of the carrier.
- Replace reflector / battery carrier in flashlight housing. Align reflector / battery carrier with the switch.
- Replace the lens bezel
OPERATION
THE NSP-2414GXL LIGHTING MODES:
MOMENTARY FLASHLIGHT MODE
Lightly press the top body switch for momentary operation. Release the switch
to turn the light off.
CONSTANT-ON FLASHLIGHT MODE
Press the top body switch until it clicks and then release for constant-on
mode. Press and release the top body switch again to turn the light off.
LASER MODE
Press the bottom body switch until it clicks and then release for laser mode.
Press and release the bottom body switch again to turn the laser off.
LASER RADIATION
CAUTION: Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous radiation exposure.
WARNING: Laser Radiation maximum power measured at less than 5mW. Avoid
direct eye exposure. Do not stare into beam. Do not turn the light on while
looking directly into the bezel.
AVOID EXPOSURE
Laser radiation is emitted from this aperture
DANGER
LASER RADIATION
AVOID DIRECT EYE EXPOSURE
MAXIMUM OUTPUT < 5mW
LASER DIODE: 520nm CLASS la LASER PRODUCT Complies with 21CFR1040,10 & 11
MFG : MM/YYYY ID: 4003544
Bayco Products, Inc. 640 S. Sanden Blvd. Wylie, TX 75098
Aperture warning and Class 3a laser labels are located on the bottom of the
light as per
illustrations above.
Complies with 21 CFR 1040.10 and 1040.11 except for conformance with IEC 60825-1 Ed. 3., as described in Laser Notice No. 56, date May 8, 2019. Manufactured at Longkou Dongli Wire and Cable Co., Ltd., 413 Beihuan Road, Huangcheng, Longkou, Shandong, China 265701.
The NSP-2414GXL is not intended to be serviced. Contact Bayco Customer Service if product is not functioning properly. See warranty section for more information.
WARRANTY
YEAR LIMITED WARRANTY
Bayco Products, Inc. warrants this product to be free from defects in
workmanship and materials to the original purchaser for 1 year from the date
of purchase, and includes the LEDs, housing, lenses, electronics, switches,
rechargeable batteries, and chargers. Bulbs (other than LEDs) are covered for
90 days from the date of purchase.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>