oceanic OCEAMAG02 Ice Maker Instruction Manual

OCEAMAG02 Ice Maker
Instruction Manual

OCEAMAG02 Ice Maker

IMPORTANT NOTICES
When using an electrical appliance, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and/or injury, including the following:

• WARNING: When positioning the appliance, ensure the supply cord is not trapped or damaged.
• WARNING: Do not locate multiple portable socket outlets or portable power supplies at the rear of the appliance.
• WARNING: Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction.
• WARNING: Do not damage the refrigerant circuit.
• WARNING: Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.
• WARNING: Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type recommended by the manufacturer.

1. Read all instructions before using them and keep them.

2. Remove all packing material and carefully check your ice maker to ensure it is in good condition and that there is no damage to the ice maker or power cord and plug.

3. Before using the Ice maker for the first time, please wait 2 hours after positioning it, and keep the transparent lid open for at least 2 hours.

4. Ensure the voltage is compliant with the voltage range stated on the rating label and ensure the earthing of the socket is in good condition.

5. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent, or a similarly qualified person in order to avoid a hazard.

6. Do not upend this product or incline it over a 45 ℃ angle.

7. To protect against risk of electric shock, do not pour water on the cord, plug, and ventilation, and immerse the appliance in water or any other liquid.

8. Unplug the appliance after using or before cleaning.

9. Keep the appliance 8cm from other objects to ensure heat release.

10. Do not use accessories that are not recommended by the manufacturer.

11. This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. Children should be supervised to ensure that they do not play with the appliance.

12. Do not use the appliance close by flames, hot plates, or stoves.

13. Do not switch on the power button frequently (ensure 5 minutes intervals at least) to avoid damage of the compressor.

14. Metal sheets or other electric objects are not allowed to be inserted into the appliance to avoid fire and short circuits.

15. Do not use outdoors.

16. Never clean with scouring powders or hard implements.

17. This appliance is intended to be used in households and similar applications such as
    – staff kitchen areas in shops, offices, and other working environments;
    – farmhouses and by clients in hotels, motels, and other residential-type environments;
    – bed and breakfast type environments; –catering and similar non-retail applications

18. To avoid contamination of food, please respect the following instructions:
    – Opening the door for long periods can cause a significant increase in the temperature in the compartments of the appliance.
    – If the refrigerating appliance is left empty for long periods, switch it off, defrost, clean, dry, and leave the door open to prevent mold from developing within the appliance

19. **** Symbol ISO 7010 W021 Danger: fire hazard / flammable material;

20. Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.

21. Refrigerants and insulating materials are flammable and can only be disposed of in an approved waste disposal site. Do not expose to flame.

SPECIFICATIONS

DESCRIPTION

1. Top lid
2. Transparent lid
3. Microswitch support
4. Ice shovel board
5. Ice collecting tray
6. Inner
7. Front housing| 8. Ice shovel
9. Buttons
10. Control panel
11. Water box
12. Bullet evaporator
13. Motor Mount
14. Rear housing
---|---

FEATURE

• Rapid ice making
• Prompt when the ice is full and water is insufficient
• Bullet ice
• 9 pcs ice cubes can be made in eight minutes
• Self-cleaning function

1. During transportation, do not tilt the machine more than 45 degrees, do not reverse the machine. This may damage the compressor and the sealing system.
2. Remove all packing materials, check the machine carefully and make sure that the machine, power cord, and plug are normal.
3. The machine should be on a level surface. To ensure sufficient ventilation, the distance of the back of the ice maker to the wall should be at least 150mm, it should be away from the oven, radiator or another heat source.
4. Before using the machine for the first time, place the machine and leave the transparent cover open for at least two hours.
5. Make sure that the home voltage is consistent with the voltage indicated by the machine.
6. Distilled water is not allowed. Mineral water is recommended.

CONTROL PANEL OPERATION

: ON-OFF switch
: Ice-making indicator light
: Ice full alarm indicator light
: Water shortage alarm indicator light

1. Plug in power, the indicator light flashes, and the machine will start the deicing function. Press the button, and the indicator light is always on and then the ice cubes will be made automatically. After the ice-making is completed, the deicing will be carried out, and then the ice shoveling function will be entered, and so on.
2. water shortage alarm When the indicator light turns red, it means that there is a water shortage in the water tank. You need to add water and press the button to restart the machine.
3. Ice full alarm When the ice reaches the maximum capacity of the ice storage container, the indicator light flashes, and the machine stops. At this time, the ice needs to be poured out. When the ice position is lower than the full sensor position, the machine will restart automatically.
4. Plug in power, and press the button for 3 seconds. The product cleaning Plug in power, press function starts. The light and the indicator light stay on. The indicator light flashes alternately. The machine first de-icing once and then starts cleaning. Each cleaning work has 5 cycles (pump water – pour water), and each cycle is about 90 seconds. Do not disconnect the power supply during cleaning. After cleaning, the machine enters standby mode automatically.

OPERATING INSTRUCTIONS

Step 1
Open the lid and take out the basket and add water to the reservoir. Note: There is a maximum scale MAX in the reservoir. The water should not exceed the MAX position. If the water exceeds the maximum scale MAX, you need to open the bottom drain plug, release the excess water, and cover it with a transparent cover.
Step 2 Plug in power and press the button to start the machine.
CAUTION

1. In The three cycles used for the first time, the ice produced is small and irregular.
2. When the ice collecting tray is full, please take out the ice immediately, do not let the ice overflow the ice collecting tray.

CLEANING & USE GUIDANCE

1. Clean the inner liner, ice collecting tray, water box, ice shovel, and evaporator frequently. When cleaning, unplug the unit and remove the ice cubes. Use a diluted solution of water and vinegar to clean the inside and the outside surface of the ice maker. Do not spray ice makers with chemicals or diluted agents such as acids, gasoline, or oil. Rinse thoroughly before starting.
2. Keep ventilation openings in the appliance enclosure, or in the built-in structure, clear of obstruction. Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.
3. Reuse the machine after being idle for a period of time, it may not have enough water to pump for air blockage. In this case, the water shortage indicator light will light up. Just repress the button to restart the ice maker.
4. To ensure the cleanness of the ice, please change the water for the water reservoir at least once one day. If do not use for a long time, please drain the water out and clean it up.
5. If the compressor takes a strike action for shortage water, full water, or interruption of power supply, it will delay for 3 minutes to start up after restarting. 6. Always use fresh water before starting ice production either at initial installation or after a long shut-off period.

TROUBLESHOOTING

1. Please note, if a power failure occurs due to the disconnection of the power cord, or the power button has been pushed off during an ice-making cycle, small ice chips may form and lodge in the automatic shovel causing it to jam. If this occurs, the ice chips may be removed by disconnecting the power cord and gently pushing the shovel to the rear of the cabinet and removing the ice chips, then restarting.
2. Please check if the water reservoir is flat when the ice shovel can not remove the ice to ice basket. If not, please push the ice shovel gently by a finger, then press the POWER button to restart.

is normal.
The water shortage indicator light is on| 1. There is no water
2. The pump is full of air| 1. Add some water until it reaches to MAX position
2. Press the POWER button to restart the machine
The indicator lights on the control panel are not on| Blown fuse/ No power| Replace fuse / Turn power on
The ice made is too large and with pieces  sticking together| The ice of previous cycles left in the water tray| Take out the ice under the standby state
The ice-making process was correct, but no ice came out.| 4. The compressor has no refrigerant
5. Compressor damaged
6. Fan motor damaged|  Call the service hotline
---|---|---
All indicators twinkle simultaneously| 1. The water box is blocked by ice.
2. The motor is stuck, or the motor falls off, or the motor is damaged
3. Micro switch damaged| 1. Unplug the power to take out the ice which under the ice shovel, then plug in power again, and press the POWER button. After 3 minutes, the machine will restart automatically.
2. Call the service hotline
The machine has been working, but the water has been warming| Solenoid broke down| Replace the solenoid valve
When the ice is full, the machine does not display the ICE FULL Icon| 1. Ice full sensor damaged
2. Sunlight interference| 4. Replace the ice full sensor
5. Making ice indoor
6. Call the service hotline

WARNING

1. If the power cord is damaged, it must be replaced by the manufacturer, its service agent, or a similarly qualified person in order to avoid a hazard.
2. Fill with potable water only.
3. It is normal for the compressor and condenser surface to reach temperatures between 70°C and 90°C during operation and surrounding areas may be very hot.
4. Due to fast freezing, ice cubes may be opaque. This is air trapped in the water and will not affect the quality or taste of ice.
5. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
6. Children should be supervised to ensure that they do not play with the appliance.
7. Do not immerse in water.

Correct Disposal of this product
This marking indicates that this product should not be disposed of with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmentally safe recycling.

120-126 Quai de Bacalan CS11584
www.oceanic.eu
33000 Bordeaux
IMPORT FROM
A.M.C.
123 quai Jules Guesde 94400 VITRY SUR SEINE
LOT #: AMC102021

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>