oceanic OCEAVT23CM2 Table Fan Diameter 23cm User Manual
- June 4, 2024
- Oceanic
Table of Contents
oceanic OCEAVT23CM2 Table Fan Diameter 23cm
Important safety instructions
Please read this instruction manual fully before using this device and keep it safe for future reference.
- This appliance is for home use only.
- Any use other than that intended for this device, or for an application other than the oneintended(e.g. commercial use), is prohibited.
- If the supply cord is damaged, it must be replaced by the manufacturer, a service agent, or asimilarly qualified person in order to avoid potential hazards.
- The fan should only be used according to the rated voltage.
- When using the fan, do not handle or push objects into the grille.
- Before moving the fan, turn off the power supply first.
- This appliance can be used by children aged from 8 years and above, and persons withreducedphysical, sensory or mental capabilities or lack of experience and knowledge, but only if theyhavebeengiven supervision or instruction concerning use of the appliance in a safe way and understandthehazards involved. Children shall not play with the appliance. Cleaning and user maintenanceshouldnotbe made by children without supervision
- Always place the device on a stable surface when using it.
- Do not let the power cord hang over the edge of a table or counter top.
- Make sure that the power cable never comes into contact with a hot surface.
- Before cleaning the fan, first disconnect from the mains, then disassemble the grille andblades. Useasoft damp cloth to wipe away grease and dust. Do not use gasoline or other corrosiveliquids.Payattention to not alter the angle of the blades.
- Water and other liquids should not be allowed to enter the motor.
- Do not cover the fan when in use.
- Unplug the fan before leaving home.
- Unplug the cord before moving.
- Do not unplug the fan by pulling on the power cable. Grasp the plug and pull it out to disconnect it.
- Do not allow hair, curtains, tablecloths and loose clothing to come into contact with thefan’smovingparts, as this may cause personal injury and property damage.
- Do not use this fan in places where flammable liquids are used or stored.
- The fan is not designed for outdoor use. The fan is for indoor use only. Do not use outdoors.
- Fan overheating protection: The fan motor is installed with a thermal fuse. When motor overheatingoccurs, the thermal fuse will cut off the power supply, and the motor temperature will stoprisingandprevent the risk of melting or burning.
- Ensure that the fan is switched off from the electrical mains before removing the guard.
- Do not try to repair this fan yourself.
- Any repair operation must be carried out by the manufacturer, its after sales service or arepair agentqualified so as to avoid danger.
Appliance specifications
TECHNICAL CHARACTERISTICS
Rated voltage| 220-240 V
Rated frequency| 50 Hz
Rated wattage| 30 W
Ambient operating temperature| 20±5 °C
Electrical protection class| II
Maximum fan flow rate| 23.41 m³/min
Fan sound power level| 48.21 dB(A)
Maximum air speed| 2.72 meters / sec
Service value| 1.0 (m³/min)/W
Seasonal electric consumption| 7.49 kWh/a
Service value measurement standard| CEI 60879 : 1986
EN 60704-2-7 :1998
EN 60704-1 :2010 + A11:
2012
EN 50564 :2011
Contact details for more information| Oceanic
120-126 Quai de Bacalan.
CS 11584
33000 Bordeaux
Description of the appliance
Part list
- Front grille
- Blade nut
- Blades
- Nut for rear grille
- Rear grille
- Body
- Oscillate button
- Screw TM2.5*10
- Nut M 2.5
Inscillation
- Loosen the fixing nut on the motor shaft. Assemble the rear grille by aligning the
- mountingstuds. 2.Tighten the nut on the grille so as to lock the grille securely on the motor.
- Push the fan blades onto the shaft
- At this moment the blades should be able to turn freely without touching the rear grille clampnut.
- Mount the front grille on the rear grille by matching the holes in which you will insert the bolt tofixthefrontgrille.
- Secure the assembly using the clips.
- Tighten the nut at the bottom of the screens.
Use
- Before using, please check the voltage and frequency is in accordance with the local power supply.
- Press the following buttons to turn on the fan: 0 – Stop 1 – Low speed 2 – High speed
- You can adjust the vertical tilt manually and select oscillate mode (from left to right) using operatingthebutton
- by pulling it up or pressing it down. You can also stop at the desired angle during oscillation by pressingdownthebutton during movement.
CARE AND CLEANING
- Always disconnect the power cord from the mains before carrying out any maintenance.
- Use a damp (NOТ WET) cloth to clean the plastic and metal surfaces.
- Never put the fan in water or any other liquid. Never use gasoline, benzene, or any other chemical tocleanthe fan.
- Never put the blades or other resin parts in hot water over 60℃.
- If the fan is not being used for a long period of time, please store it in a dry place.
DISPOSAL OF WASTE
| As a responsible distributor, we attach great importance to the protection
of the environment.We encourage you to follow the correct disposal procedures
for your device, batteriesandpackaging. This will help to conserve natural
resources and ensure that the product anditsparts are recycled in a way that
is respectful of health and the environment.
---|---
You must dispose of this product and its packaging according to local laws and regulations. Since this product contains electronic components and sometimes batteries, the product anditsaccessories should be disposed of separately from household waste when the product reachestheendof its life
For more information on disposal and recycling procedures, contact the
authorities in your local area.
Take the device to a local collection point for recycling. Some centers accept
products for free.
Oceanic
120-126 Quai de Bacalan
CS 11584
33000 Bordeaux
Imported by:
A.M.C
123, QUAI JULES GUESDE
94400 VITRY SUR SEINE
France
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>