oceanic OCEAVP45B2 Remote Control Stand Fan User Manual

: June 4, 2024
: Oceanic

Table of Contents

Important safety instructions:
Appliance specifications
Structure:
USE
CARE AND CLEANING
DISPOSAL OF WASTE
Read User Manual Online (PDF format)
Download This Manual (PDF format)

OCEAVP45B2 Remote Control Stand Fan
User Manual

Important safety instructions:

Read this user guide completely before using this device and keep it safe for future reference.

This appliance is for home use only.
Any use other than that intended for this device, or for an application other than the one intended (e.g. commercial use), is prohibited.
If the power cord is damaged, it must be replaced by the manufacturer, a service agent, or a similarly qualified person in order to avoid a hazard.
The fan should only be used according to the rated voltage.
When using the fan, do not handle or push objects into the grille.
Before moving the fan, turn off the power supply first.
This appliance can be used by children aged 8 years and above, and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge, but only if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance should not be made by children without supervision
Always place the device on a stable surface to use it.
Do not let the power cord hang over the edge of a table or countertop.
Make sure that the power cable never comes into contact with a hot surface.
Before cleaning the fan, first, disconnect from the mains, then disassemble the grille and blades. Use a soft damp cloth to wipe away grease and dust. Do not use gasoline or other corrosive liquids. Pay attention to not altering the angle of the blades.
Water and other liquids should not be allowed to enter the motor.
Do not cover the fan when in use.
Unplug the fan before leaving home.
Unplug the cord before moving.
Do not unplug the fan from the power cable. Grasp the plug and pull it out to unplug it.
Do not allow hair, curtains, tablecloths, and loose clothing to come into contact with the fan’s moving parts, as this may cause personal injury and property damage.
Do not use this fan in places where flammable liquids are used or stored.
The fan is not designed for outdoor use. The fan is for indoor use only. Do not use outdoors.
Fan overheating protection: The fan motor is installed with a thermal fuse. When motor overheating occurs, the thermal fuse will cut off the power supply, and the motor temperature will stop rising and prevent the risk of melting or burning.
Ensure that the fan is switched off from the electrical mains before removing the guard.
Do not try to repair this fan yourself.
Any repair operation must be carried out by the manufacturer, its after-sales service, or a repair agent qualified so as to avoid danger.

Appliance specifications

TECHNICAL CHARACTERISTICS

HOW TO ASSEMBLE THE STANDING FAN
Your fan has been boxed unassembled to minimize packaging waste. Each part is designed to easily fit together and be disassembled for cleaning or storage.
Ensure the fan is disconnected from the power outlet before assembling.

Structure:

oceanic OCEAVP45B2 Remote Control Stand Fan -
Structure

1. Front grille	9. Screw D
2. Blade nut	10. Extension pole
3. Blade	11. Height adjustment lock
4. Nut for the rear grille	12. Base tube
5. Rear Grille	13. Cross shaft
6. Motor	14. Crossbracket
7.”Oscillation” button	15. Remote control
8. Body	16. Grille lock

USE

Remove the cable tie and unravel the cord before operation.
The fan and motor assembly are attached to a 3-position ratchet. Tilt the unit up or down until it locks in the desired position.
Press the speed button to adjust between low-medium-high settings.

Fan body

oceanic OCEAVP45B2 Remote Control Stand Fan - Fan body

Remote control

Remote Control Battery Compartment

Please ensure that the batteries are inserted in the correct direction.
Do not mix battery types.
When replacing, ensure both batteries are changed at the same time.
2 x AAA size batteries required
Batteries should not be exposed to excessive heat such as sunlight or fire.
Batteries should be recycled or disposed of properly.

Press the ON/OFF button to switch the fan on and off. When switched on, press the SPEED button to make the fan switch from one speed to another, from low to high speed. The corresponding will LED light up on the fan body.

Push or pull the OSC button on the motor to oscillate the head or keep it in a fixed position.

When first switched on, the MODE LED will glow red indicating that the unit will operate in normal mode. The TIMER key adjusts or turns off the timer. Timings between0.5-7.5hrs can be selected.
You can set the operating time by successively pressing the TIMER button. When an indicator light remains fixed for one of the durations (0.5h, 1h, 2h, 4h) this means that the following presses will add up: 1 hour fixed followed by one press will turn on the indicator lights for 0.5h and 1h, bringing the total duration to 1.5h.
the same applies up to a maximum duration of 7.5h (all the LEDs will be on 0.5

1h + 2h + 4h = 7.5h). “

Remote control operations are identical to the functions on the fan control panel.

Press the Sleep, Natural and Normal mode buttons to select the required mode.
Natural mode:

With medium speed selected, the speed alternates between medium and low speeds.
With a low speed selected, the fan will alternate between low speed and the idle position.

Sleep mode:

The fan will operate at high speed in Natural mode for 30 minutes, at medium speed in Natural mode for 30 minutes, and then it will operate at low speed in Natural mode for the remaining time.
The fan will operate at medium speed in the natural mode for 30 minutes, and then at low speed in Natural mode for the remaining time.
With low speed selected: The fan will operate at Low speed in Natural mode.

CARE AND CLEANING

Always turn off the fan and unplug it from the power outlet before cleaning.
Clean the fan with a slightly damp cloth, then dry it. Do not immerse the motor housing in water or any other liquid. Do not use chemical or abrasive cleaners.

Storage
When you are not using the fan, store it in a dry and secure place.

If stored disassembled, it is recommended that you use the original box (or an appropriately sized box).
If stored assembled or partially assembled, protect the fan head from dust.

DISPOSAL OF WASTE

As responsible distributors, we attach great importance to the protection of the environment.
We encourage you to follow the correct disposal procedures for your device, batteries, and packaging. This will help to conserve natural resources and ensure that the product and its parts are recycled in a way that is respectful of health and the environment.

You must dispose of this product and its packaging according to local laws and regulations.
Since this product contains electronic components and sometimes batteries, the product and its accessories should be disposed of separately from household waste when the product reaches the end of its life.

For more information on disposal and recycling procedures, contact the authorities in your local area.
Bring the device to local collection point for recycling. Some centers accept products free of charge.

Oceanic
120-126 Quai de Bacalan
CS 11584
33000 Bordeaux
Imported by:
A.M.C.
123, QUAI JULES GUESDE
94400 VITRY SUR SEINE
France

www.oceanic.eu