Ningbo XB-BJ12000 V7 Vandlion Voice Recorder Audio Instructions
- June 16, 2024
- Ningbo
Table of Contents
Ningbo XB-BJ12000 V7 Vandlion Voice Recorder Audio Instructions
Product Information
Specifications:
- Remote control distance: 26 meters
- Frequency: 315MHz
- Emitter voltage: DC3.0V
- Receiver voltage: DC9-15V
Product Usage Instructions
Power On/Off:
- Press and hold the Start button for 3 seconds to turn on the device.
- The blue wireless indicator light will stay on to indicate power is on.
- The device will automatically turn off within 2 minutes of inactivity.
Winch Output:
To activate the winch output, follow these steps:
- Press the OUT button on the remote control.
- The blue indicator light will flash to indicate winch output.
- Choose between nylon rope or steel wire rope depending on your setup.
Winch Wire Entry:
To make the winch enter the wire, follow these steps:
- Press the IN button on the remote control.
- The blue indicator light will flash to indicate winch wire entry.
- Choose between nylon rope or steel wire rope depending on your setup.
Remote Control Instructions
The function description of panel buttons is shown in the figure.
Function description
- Press and hold the start button for 3 seconds to turn on the device, and the blue wireless indicator light will stay on.
- Automatically turn off power within 2 minutes without any operation.
- Press the OUT button and the blue indicator light will flash to indicate the winch output (nylon rope/steel wire rope).
- Press the IN button and the blue indicator light will flash for the winch to enter the wire (nylon rope/steel wire rope).
Remote control distance:
- 26 meters, frequency : 315MHz
The transmitter should automatically shut down without any operation after being turned on.
-
Emitter voltage:
DC3.0V -
Receiver voltage :
DC9-15V
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Frequently Asked Questions
What is the remote control distance?
The remote control has a range of 26 meters.
What is the frequency of the remote control?
The remote control operates at a frequency of 315MHz.
What happens if I don't use the remote control for a while?
The transmitter will automatically shut down if there is no operation after being turned on.
What are the voltage requirements for the emitter and receiver?
The emitter requires DC3.0V, while the receiver needs DC9-15V.
Can I use the device in portable exposure conditions?
Yes, the device has been evaluated to meet general RF exposure requirements and can be used without restriction in portable exposure conditions.