NINGBO M10AF 10 Inch Active Monitor Speaker User Manual
- June 1, 2024
- Ningbo
Table of Contents
M10AF 10 Inch Active Monitor Speaker
User Manual
Safety Precautions :
Fixing and installation of this speaker cabinet must be carried out by
qualified personnel following the approved safety standards.
Do not attempt to clean the plastic enclosure with solvents or petrochemical
based cleaners.
Do not place objects which are sources of heat on the speaker cabinet such as
lighting equipment or smoke machines.
Do not expose the speaker cabinet to direct rain or stand in water. Liquid
getting into the box will risk a short circuit and will be hazardous.
Do not stack the speaker cabinet in a manner that could cause injury should a
cabinet become dislodge.
Additional precautions for Auto-amplified devices of the series.
Before installation, ensure that the voltage and frequency of power outlet
match the power requirements of the loudspeaker.
Disconnect from main power before to make connections in the loudspeaker.
Make sure that the power-cord is never crimped or damaged by sharp edges.
Never let the power- cord come into contact with other cables. Only handle the
power-cord by the plug.
In case to replace the fuse, it must be changed by identical rate and
dimensions.
Attention
Before connecting or operating your new loudspeaker, please study the
accompanying instruction manual paying special attention to the operating
precautions and wiring procedure.
This symbol on the product or on Its packaging indicates that this product
shall not be treated as household waste. Instead it shall be handed over to
the applicable collection point for the recycling of electrical an electronic
equipment By ensuring this product is disposed of correctly, you will help
prevent potential negative consequences for the environment and human health,
which could otherwise be caused by inappropriate waste handling of this
product The recycling of materials will help to conserve natural resources.
For more detailed information about recycling of this product, please contact
your local city office, your household waste disposal service or the shop
where you purchased the product.
Panel posterior
Functions
- DSP management controller light : there has Normal.DJ.VOICE.LIVE.FLAT for choose.
- Power LED : When lit, the power is on. Signal LED :When lit, the signal presence at the audio input. CLIP LED :When lit, the input signal level is excessive and should be reduced.
- DSP management controller light : there has Normal.DJ.VOICE.LIVE.FLAT for choose.
- Bluetooth: Hold for 3 to 5 seconds, When the light comes on, it can be connected to device.
- RCA Line input.
- LINE: Line input
- RCA/LINE Volume Controller
- Input sensitivity switcher: Line: normal mode Mic: the input sensitivity is set to MIC level, suitable for the direct connection of a dynamic microphone. Do NOT use this setting when connected to a mixer output.
- Link Output :Connect this interface, can provide a signal to another active speaker.
- MIC/LINE: it can switch from line and mic
- MIC/LINE Volume Controller.
- Power Switch : ON/OFF function
- Power cord input :Before connecting the power cord, check if the mains corresponds to the voltage indicated on the rating plate on the unit. Connect the power cord only to a mains socket outlet with a protective earthing connection
Warning Statement
This device com plies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) Th is device may not cause harmful
interference, and (2) this dev ice must accept any interference received ,
including interference that m a y cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for
com pliance could void the user’ s authority to operate the equipment.
Note: This equipm ent has been tested and found to com ply with the
limits for a Class B digital device, pursuant to part 15 of th e FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipm ent generates uses and can radiate radio frequenc y energy and, if
not installed and used in accordance with the instructions, m a y cause harm
ful interference to rad io communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipm ent
does cause harm ful interference to radio or television recep tion, which can
be determined by turn ing the equipment off and on, the user is encouraged to
try to correct the interference by one or m o re of the following measures:
-Reorient or relocate the receiving antenna.
-Increase th e separation between the equipm ent and receiver.
-Connect the equipm ent into an outlet on a circuit different f r om that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>