NINGBO JF2117S Wireless Fast Charging Pad User Manual
- June 1, 2024
- Ningbo
Table of Contents
WIRELESS FAST CHARGING PAD
USER MANUAL
Supplied Accessories:
- FCC ID:2BAZE-JF2117S
- REF : JF2117S
- Input：5-9VDC, 13W
- Output：Max. 10W
Features:
- Works with compatible mobile phones
- IK08 shock resistance
- Strong magnets on the rear allow for easy mounting on magnetic surfaces as well as builtin screw holes for permanent mounting
Specifications:
-
Material: Ultra tough nylon, Aluminium,Rubber , PC& TPE
-
If charging by wireless pad:
Charging time: Approx 3.0-8.0 hours depending on battery pack – the environmental temperature will affect the charging and discharging period of the battery -
Operating temperature: -5°C to +30°C
Disposal and environmental protection
- Do not dispose of charging pad with domestic waste
- Please check with local recycling plants for the best way to recycle
- This charging pad contains substances that may be harmful to the environment and humans if disposed of inappropriately
FCC Warning
- This device complies with Part 18 of the FCC Rules.
- Refer to Part 18.213(c) and KDB 784748 Annex A section A.5:
- Max. Electric Field Emissions: 6.06V/m
- Max. Magnetic Field Emissions: 0.54A/m
- The maintenance of the system is the responsibility of the manufacturer.
- To prevent interference, the product should be as far away from devices operating at the same frequency as possible.
- RF exposure considerations
- This equipment complies with the FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and any part of your body.
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 18 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
MPE caution
To satisfy FCC / IC RF exposure requirements, a separation distance of 20 cm
or more should be maintained between the antenna of this device and persons
the antenna of this device and persons during device operation. To
ensurecompliance, operations at closer than this distance is not recommended.
Ningbo Weijia Electronics Technology Co., Ltd.
How to use the lamp ?
A: Indicator light
B: Magnet
C: Charge coil
D: Mobile phone support
E: TYPE-C
F: Magnet
G: hanging hole
- Wireless fast charging pads can be sucked onto iron plates
- Wireless series lights can be charged
- Support to charge your cell phones(induction charging allowed).
Ningbo Weijia Electronics Technology Co., Ltd.
Made in China
JF2117S