Ningbo Joinus Win Future Electronic Technology UHRT05C Remote Transmitter Instruction Manual
- June 3, 2024
- Ningbo Joinus Win Future Electronic Technology
Table of Contents
Instruction Manual for Remote Transmitter
Model No.: UHRT05C (JHT2202B)
INSTALLATION AND CHANGE THE BATTERY:
Open the battery compartment which on the back of remote control, Install one (1) x 12V (23A) battery in the compartment, make sure the positive and negative electrodes of battery is correct.
OPERATION:
There are five pairs of buttons on remote control for individual ON and OFF
function.
Each push of the ON or OFF button on remote controller will turn on or off the
corresponding receivers accordingly.
TECHNICAL DATA:
Transmission Frequency: 433.92MHz
Transmitter : DC 12V 23A battery (1pc)
Working temperature: -20℃ to + 50℃
Other Details:
The transmitter can be sold separately, but can not be used separately, it
will have to be matched corresponding radio receivers to use.
The transmitter can only turn ON or OFF the corresponding receivers
individually on 70 to 100ft distance. The corresponding receivers such as
socket, light bulb socket, switch kit, etc.
Troubleshooting:
If you find the remote control distance becomes short or the indicator on
remote transmitter becomes weak, then please replace the battery with fresh
battery asap.
Please check if the positive and negative of the battery installation is
correct if the remote control is no response or the indicator on remote
control is not on when press any one of the key buttons.
Regular change fresh battery for best use.
FCC Statement
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment. This
device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.
Note : This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>