Simply Retrofits 2ft Architectural Linear Fixture User Manual
- June 15, 2024
- Simply Retrofits
Table of Contents
Simply Retrofits 2ft Architectural Linear Fixture
Linear Architectural Light User Manual
All the pictures are just for references.
Safety Information
- CAUTION! Risk Of Electrical Shock
- Turn off all power prior to installation by switching off circuit breaker or removing fuse at fuse box.
- This product should be installed by a certified electrician in accordance with relevant federal, state and local building and electrical codes
Common Failures & Solutions
Size
Suspension installation
Surface Installation
WALL INSTALLATION
Upper Luminous Module Assembly
CONTINOUS INSTALLATION
Pull the power cord of the fixture on the right to the fixture on the left inside of fixture body, and connect the wires one by one with quick connector. As shown in Figure 3.
Put end cap A, end cap B and cover plate on
” L” Joint Installation
- Use a screwdriver to lift the top cover; Remove the magnetic end cap a and the spring end cap b by hand, as shown the left Figure.
- Insert terminal pin to one side of fixture. And then insert H mechanical joiner into one side of fixture. Then please connect fixture to “L” corner kit. Check if the terminal pin is connected normally.
- The other side connection is same as the last step.
- Power cord has two ways to be connected. Way one: Every fixture are power by its own power cord as below figure 1 shown.
- Way two : Fixture connected in in series. Pull the AC line
- Put cover plate on. of second fixture to first fixture inside of fixture body, and connect the wires one by one with quick connector. As shown in Figure 2.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>