WALI MF001 Single Monitor Desk Stand Instruction Manual

WALI MF001 Single Monitor Desk Stand Instruction Manual

WARNING!

If you do not understand these directions, or if you have any doubts about the safety of the installation, please call a qualified technician.
Check carefully to make sure there are no missing or defective parts.
Improper installation may cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual. Do not exceed weight capacity. We cannot be liable for damage or injury caused by improper mounting, incorrect assembly or inappropriate use.

TIPOVER WARNING

SERIOUS OR FATAL CRUSHING INJURIES CAN OCCUR FROM TIPOVER.
TO HELP PREVENT TIPOVER: NEVER ALLOW CHILDREN TO CLIMB, STAND, HANG, OR PLAY ON ANY
PART OF MONITOR OR STAND.+ _USE TIPOVER RESTRAINT OR ANCHOR STAND TO WALL.
USE OF TIPOVER RESTRAINTS MAY ONLY REDUCE, BUT NOT ELIMINATE RISK OF TIP OVER.SMALL PARTS- NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.

Supplied Parts List

Step 1

Install the Pole @ to the Weighted Base @using Bolts @ and tighten with Allen Key 3mm @.

Step 3

Put the Wire Clip@@and Monitor Arm @ through the Pole @ , adjust the preferred height and tighten using A Allen Key 6mm

Step 3

Step3.1   Em. Select TV Screws.

Step 3.2

Select Spacers (if needed )

Step 3.3 aFlat Back Monitor

Select M4x12 Bolt Q) or Msx12 Bolt (T® according to your TV/Monitor, connect VESA Plate @) together with DS Washer Q@ into the mounting
Select M4x16 Bolt Q) or M5x16 Bolt (D according to your TV/Monitor, connect VESA Pla together with DS Washer Q3 and Spacer @R into holes on the back of TV/Monitor, tighten with screwriver. (Screwdriver needed but not included)

Step 3.3 b Curved Back Monitor

Select M4x16 Bolt Q) or M5x16 Bolt (D according to your TV/Monitor, connect VESA Pla together with DS Washer Q3 and Spacer @R into he mounting holes on the back of TV/Monitor, ighten with screwdriver. (Screwdriver needed but not included)

Step 4

Put the assembled TV/Monitor onto the Monitor Arm @ and ensure stability, tighten the VESA Plate @ using Nut@.

Step 5

Tighten or loosen tilt joint using Allen Key Smm @.

Step 6

Guide the cable through the Wire Clip @)

Step 7

Store the Allen Keys in the Wire Clip@®

Step 7

Manually swivel, ilt or rotate the angle for the best operating environment.

Thank you for choosing

We support the technology that brings your home to ife We offe high quality products, professional customer service, and extensive technicalsupport.

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>