WANTJOIN Hot Dog Steamer 2 Tiers Electric Hot Dog Steamer User Manual

June 16, 2024
Wantjoin

WANTJOIN-logo

WANTJOIN Hot Dog Steamer 2 Tiers Electric Hot Dog Steamer

WANTJOIN-Hot-Dog-Steamer-2-Tiers-Electric-Hot-Dog-Steamer-
product

Product Information

Specifications

  • Stainless steel roof: 1
  • Top stainless steel plate: 2
  • Side slide rail stainless steel plate: 2
  • L-shaped leak stainless steel plate: 2
  • U-shaped stainless steel plate: 1
  • Glassdoor: 2
  • Back glass: 1
  • Drain valve: 1
  • Type A Screw Nut: 12
  • Type B screw: 1
  • Type C screw: 7
  • Type D screw: 8
  • Stainless steel base: 1

Installation

  1. Install 2 pieces of stainless steel iron plate with slide rails on the side of the base with A-type screws and nuts.
  2. Put the back of the glass.
  3. Install the stainless steel roof on the stainless steel roof with C-type screws.
  4. Fix the accessories formed from Step 3 to the iron plates on both sides with A-shaped screws.
  5. Place two L-shaped leaky stainless steel plates as shown in the figure.
  6. For front and rear misalignment, install 2 pieces of glass doors.
  7. Wrap the drain with white tape, and then install the drain valve.

How to Use

  1. Fill the water tank with water. Ensure the water level is within the MIN and MAX guide.
  2. Plug in the cable and turn on the power switch. Preheat the machine for 15 minutes.
  3. Place the food in the warmer. Note that all frozen baked bread must be warmed up for 15 minutes before eating.
  4. When the red indicator lights on, fill the water in the machine to avoid dry burning.

Troubleshooting

  • Cold/Frozen Bread Taste
  • Cause: Not enough preheat time
  • Solution: Preheat for 15 minutes
  • Cause: Heat preservation is not enough
  • Solution: Place the food in the warmer and wait for 15 minutes before eating

Smoky and Smelly

  • Cause: Protection oil film and first-time using heat pipe
  • Solution: Clean with a cloth and warm up for 15 minutes

Machine Not Heating Up with Red Indicator Lights On

  • Cause: Run out of water, the machine stops heating
  • Solution: Switch off the power, add enough water by following the MIN/MAX water level guide

Cleaning and Maintenance

  1. Turn the right tap from the machine to empty the water tank.
  2. The glass door and shelf can use the dishwasher to clean.
  3. Use a non-corrosive washing liquid and cloth to clean the cabinet.
  4. Never immerse or use water to spray on the machine to clean.

Warnings

  • DO NOT touch the hot surface to avoid burns.
  • DO NOT immerse the product and cable in the water to avoid electric shock.
  • MUST beware of all ages under 18 or areas near children when using.

FAQ

Q: How long should I preheat the machine?

  • A: Preheat the machine for 15 minutes.

Q: Can I clean the glass door and shelf in a dishwasher?

  • A: Yes, the glass door and shelf are dishwasher-safe.

Q: What should I use to clean the cabinet?

  • A: Use a non-corrosive washing liquid and cloth to clean the cabinet.

Q: Can I immerse or spray water on the machine to clean it?

  • A: No, never immerse or use water to spray on the machine to clean.

WARNING

Please follow and read carefully the following safety notice before using the product:

  1. DO NOT touch the hot surface to avoid burns.
  2. DO NOT immerse product and cable into water to avoid electric shock
  3. MUST beware of all ages under 18 or areas near children when using the product.
  4. UNPLUG the product and let it cool down before cleaning or after using.
  5. ONLY find the nearby authorized service agency for inspection, repair, and adjustment when the appliance, cable, or cord is damaged
  6. NEVER use not from the manufactured electrical appliance to avoid injury.
  7. NEVER for outdoor use.
  8. DO NOT hang the wires on table edges or any hot surface.
  9. DO NOT operate or place the product near hot gas or electric stoves.
  10. MUST be careful when moving the machine that contains hot oil to avoid burns.
  11. MUST turn off all control or function keys before you unplug the product.
  12. NEVER use the product for other purposes.
  13. KEEP and SAVE the instruction properly

FUNCTION FEATURE

  1. Type A Screw Nut*12
  2. Type B screw*1
  3. Type C screw*7
  4. Type D screw*8
  5. Stainless steel base*1
  6. Stainless steel roof *1
  7. Top stainless steel plate*2
  8. Side slide rail stainless steel plate*2
  9. L-shaped leak stainless steel plate*2
  10. U-shaped stainless steel plate*1
  11. Glass door*2
  12. Back glass*1
  13. Drain valve*1

INSTALLATION

  1. Install 2 pieces of stainless steel iron plate with slide rails on the side on the base with A-type screws and nuts.
  2. Put the back of the glass.
  3. Install the stainless steel roof on the stainless steel roof with C-type screws.
  4. Fix the accessories formed from step 3 to the iron plates on both sides with  A-shaped screws.
  5. Place two L-shaped leaky stainless steel plates as shown in the figure
  6. Front and rear misalignment, install 2 pieces of glass doors
  7. Wrap the drain with white tape, and then install the drain valve

HOW TO USE

  1. Fill the water to the water tank. Water should not be either lower than the MIN guide or higher than the MAX guide.
  2. Plug the cable by turning on the power switch. Preheat the machine for 15 minutes.
  3. Place the food in the Warmer. Please mark that all frozen baked bread must be warmed up after 15 minutes before eating.
  4. When the red indicator lights on, please fill the water to the machine to avoid dry burning in the machine.

TROUBLESHOOTING

Issue Name Cause of Issue Solution
**** Cold/ Frozen bread taste 1.   Not enough Preheat time

2.   Heat preservation is not enough

| 1.  Preheat for 15 minutes

2.   Place the food in a warmer & wait for 15mins before eating

Smoky and Smelly First Time Using| Protection oil film and Heat pipe| Normal phenomenon, use a cloth to clean and warm up for 15 minutes.
The machine not heating up with the red indicator lights on| Run out of water, machine stops heating| Switch off the power, add enough water by following the MIN/MAX water level guide

CLEANING AND MAINTENANCE

  1. Turn the right tap from the machine to empty the water tank water.
  2. The glass door and shelf can use the dishwasher to clean.
  3. Use a non-corrosive washing liquid and cloth to clean the cabinet.
  4. Never immerse or use water to spray on the machine to clean

For your safety, please read the manual before using the HOT DOG WARMER.

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Related Manuals