WANTJOIN Adjustable Temperature 2-Tier Electric Hot Dog Steamer User Manual

May 15, 2024
Wantjoin

WANTJOIN-LOGO

WANTJOIN Adjustable Temperature 2-Tier Electric Hot Dog Steamer

WANTJOIN-Adjustable-Temperature-2-Tier-Electric-Hot-Dog-Steamer-
PRODUCT

FUNCTION FEATURE

WANTJOIN-Adjustable-Temperature-2-Tier-Electric-Hot-Dog-Steamer-FIG-
\(1\)

INSTALLATION

  1. Align the rubber feet with the hole of the base & tighten them clockwise.
  2. Align the top plate with the hole position of the sloped roof & tighten with M5 screw.
  3. Align the installed sloping roof with the holes of the base, and tighten it with M5 screws & nuts.
  4. Install the drain valve, first using the raw tape to tie 7-8 circles of the outer & tighten it clockwise.
  5. Fix the handle on the glass door with the M4 screws.
  6. Align the left & right side panels to the hole of the base with M5 screws & nuts.
  7. Put the rear glass vertically into the back card slot.
  8. Use M5 screws & nuts to fix the hooks on the side fuselage.
  9. Install the middle layer board &  The L-shaped base plate inside the fuselage.
  10. Insert the glass door into the upper glass slot in left & right order. Place the card slot vertically.

HOW TO USE

  1. Fill the water in the water tank inlet to a maximum water level of not more than 7L of water.
  2. Connect the power supply, turn on the switch & adjust the temperature of the button according to the temperature requirement.
  3. Preheat for 15 to 20 minutes before adding food.
  4. Turn off the power when not in use. Open the faucet on the right-hand side of the machine. Drain the water in the water tank.
  5. Clean the machine with a clean wipe to avoid the machine becoming smelling or mouldy.

WARNING
Please follow and read carefully the following safety notice before using the product:

  1. DO NOT touch the hot surface to avoid burns.
  2. DO NOT immerse the product and cable in the water to avoid electric shock
  3. MUST be aware of all ages under 18 or areas near children when using the product.
  4. UNPLUG the product and let it cool down before cleaning or after using.
  5. ONLY find the nearby authorized service agency for inspection, repair and adjustment when the appliance, cable or cord is damaged
  6. NEVER use not from the manufactured electrical appliance to avoid injury.
  7. NEVER for outdoor use.
  8. DO NOT hang the wires on the table edges or any hot surface.
  9. DO NOT operate or place the product near a hot gas or electric stove.
  10. MUST be careful when moving the machine that contains hot oil to avoid burns.
  11. MUST turn off all control or function keys before unplugging the product.
  12. NEVER use the product for other purposes.
  13. EEP and SAVE the instruction properly

LOLCANING AND MAINTENANCE

  1. Turn on the faucet on the right-hand side of the machine, to drain the water in the water tank.
  2. Clean the glass door & shelves with faucet.
  3. Use cleaning fluid & wipe to clean the surface.
  4. Do not soak or spray the machine with water for cleaning.

TROUBLESHOOTING

Q1. The machine cannot be started
ANSWER:
Please preheat for 15 minutes before use.

Q2. Smoky smell when first used
ANSWER:
Protected Heating pipe by an oil film, is a normal phenomenon. Clean it with a wipe & preheat it for 15 minutes.

Q3. The machine does not heat & the red indicator light comes on.
ANSWER:
The water in the sink has been used up. The machine stops heating. Turn off the power & refill water according to the maximum water level.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals