LUMASCAPE Centria C3 LS1015 Remote Driver Surface Mount Adjustable Spotlight Installation Guide
- June 15, 2024
- LUMASCAPE
Table of Contents
Centria C3 LS1015
USA | Australia | Asia | Middle East | Europe
INSTALLATION INSTRUCTIONS
REMOTE DRIVER SURFACE MOUNT ADJUSTABLE SPOTLIGHT
WARNING
Install in accordance with National Electric Code, ANSI/NFPA 70 or the
Canadian Electrical Code, Part I (CEC), CSA C22.1
READ ALL SAFETY INSTRUCTIONS FIRST
- Follow instructions carefully, failure to do so will void warranty.
- Ensure installation complies with local law and applicable standards.
- Input voltage is 30 to 48 Vdc
- Only use Lumascape power supply, control equipment and leader cables.
- Ensure mains input power is surge protected.
- Never make connections whilst the power is connected.
- Do not make modifications or alter the product.
- Keep luminaire and connections clean and free of debris and moisture.
- It is the installers responsibility that the installation is adequately sealed to avoid moisture ingress.
-
Supply Cable
Run a suitable 3-core supply cable from the Low Voltage PowerSync™ Master to the luminaire. -
Cable Gland
Feed the supply cable through the cable gland and tighten. Outer diameter of cable should be Ø5-10mm (Ø0.2-04″) for use with gland. -
O-Ring
Make sure it is firmly in place when tightening gland. -
Terminal Block
Connect supply cable to terminal block. -
Lid Screws
Use to attach luminaire base. -
Gasket Seal
Place between mounting surface and back of luminaire. -
Mounting Screws
Use to attach luminaire base to mounting surface. -
LED Driver Cables
Connect to terminal block if required. Refer to table for conductor colour and designation. -
Seal
Make sure the seal is correctly in place luminaire and base. -
Luminaire Rotation
Loosen to adjust luminaire rotation. Tighten to lock rotation into place. -
Luminaire Tilt
Loosen to adjust luminaire tilt. Tighten to lock tilt into place.
Power supply must be isolated prior to connection or disconnection of cables. Failure to do so will result in damage to the luminaire components.
| Colour| Designation
---|---|---
| Red| 30 to 48 DC+
| Black| 30 to 48 DC–
| Orange| Data
LUMASCAPE ASIA PACIFIC Brisbane Technology Park, 18 Brandl Street, Eight
Mile Plains, QLD 4113, Australia
Phone +61 7 3854 5000 | Fax +61 7 3854 5001 | Email:
sales@lumascape.com.au |
www.lumacape.com
LUMASCAPE NORTH AMERICA 1940 Diamond Street, San Marcos, CA 92078, USA
Phone +1 650 595 5862 | Email: info@lumascape.com |
www.lumacape.com
Products and specifications are subject to change without notice.
IN0183US N181130
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>