kaboodle KITCHEN 600mm Medium Wall Cabinet Instruction Manual
- June 15, 2024
- kaboodle KITCHEN
Table of Contents
kaboodle KITCHEN 600mm Medium Wall Cabinet
Product Information
Specifications
- Product: 600mm Medium Wall Cabinet
- Hardware included:
- 50mm wood screws x 20 (A)
- 28mm wood screws x 5 (B)
- Shelf support x 4 (C)
- Stick on end caps x 5 (D)
- Door buffer x 4 (E)
- Tools required:
- Countersinking drill bit
- Tape measure
- Pencil
- Clamps (quick release)
- Safety gear
- Adjustable square
- 65mm wood screw
- Spirit level (900mm recommended)
- Wall fixing (if necessary)
- Cabinet stand
Product Usage Instructions
Step 1: Building and Attaching the Cabinet
- Assemble the cabinet frame by following the instructions provided in the hardware key section.
- Install the adjustable shelf by following the instructions provided in the hardware key section.
- Install the doors according to your specific needs. Note that if you are using this cabinet for an undermount rangehood, you will need to use 2 x 300 medium rangehood doors and ensure the minimum clearance requirements are met as per AS/NZ Standards.
Step 2: Joining Cabinets
- If you need to add an end panel, refer to the end panel instructions for installation tips.
- Align the cabinets using cabinet supports and hold them together using clamps.
- Ensure the distance between the benchtop and wall cabinet is a minimum of 450mm as per AS/NZ Standards.
- Check that all cabinets are level, then pre-drill and screw them together.
- When attaching the cabinets to a timber stud wall, use a minimum of 65mm timber screws. Seek advice from a hardware specialist if attaching to other substrates.
Caring for Your Kaboodle Cabinets
To ensure the longevity of your cabinets, follow these care instructions:
- If the melamine surface of your cabinet is damaged, you can try covering it with a furniture repair crayon. However, note that this won’t seal the board back to its original finish.
- For any additional information or assistance, contact our customer service:
- Australia : 1800 666 078 (Monday to Friday between 8:00am and 6:00pm AEST)
- New Zealand : 0800 522 663 (Monday to Friday between 8:00am and 5:00pm NZST)
- Email : info@kaboodlegroup.com.au
FAQ
-
Q: Can I use this cabinet for an undermount rangehood?
A: Yes, this cabinet can be used for an undermount rangehood. Make sure to use 2 x 300 medium rangehood doors and follow the minimum clearance requirements as per AS/NZ Standards. -
Q: What is the minimum distance between the benchtop and wall cabinet?
A: The minimum distance between the benchtop and wall cabinet should be 450mm as per AS/NZ Standards.
Step 1
Follow these instructions to build and attach your cabinet.
Things you need to know
- All cabinets will need to be attached to the wall using a minimum of 8 gauge 65mm screws if you have a stud wall. If your wall is concrete, brick or another surface ask your hardware specialist for advice on the right fixing method.
- Make sure you leave plumbing and electrical work to qualified trades people. Never try this yourself.
- For extra strength use exterior woodworking glue when assembling cabinets.
- To help identify panels, counter sunk holes always face outwards.
- All holes that aren’t already pre-drilled should be drilled prior to screwing using a No 12 countersinking drill bit.
- Make sure you always use safety gear like a mask, ear muffs and glasses when using tools.
- If you have any questions, contact us on: Australia: 1800 666 078 Monday to Friday between 8:00am and 6:00pm AEST, New Zealand: 0800 522 663 Monday to Friday between 8:00am and 5:00pm NZST or email: info@kaboodlegroup.com.au
Hardware included
Tools you will need
To put your kaboodle kitchen cabinets together you will need the following
tools.
Hardware key
Assembling cabinet
Installing adjustable shelf
Installing doors
This cabinet can be installed with 2 x 300 medium wall cabinet doors for
standard use, or 2 x 300 medium rangehood doors if required for an undermount
rangehood.
Note: AS/NZ Standards state the minimum clearance to the underside of the
rangehood is 650mm from the trivet for gas and 600mm for electric cooktops or
the appliance specification, whichever is greater. Be sure to check your
appliance specifications before completing your installation.
hardware key
**Joining cabinets
**
-
With the aid of cabinet supports align cabinets and hold together using clamps.
Tip : If a pantry has been installed, align wall cabinets to the height of the pantry.
Note : AS/NZ standards states that the distance between the benchtop and wall cabinet needs to be a minimum of 450mm. -
Check all cabinets are level then pre-drill and screw cabinets together.
Fixing cabinets to wall
Caution : Please ensure all cabinets are screwed into your timber stud wall using a minimum of 65mm timber screws. If attaching to concrete, brick, steel or any other substrates seek advice from your hardware specialist
Caring for your kaboodle cabinets
- Looking after your cabinets is really easy and with the right care and maintenance they will last you for many years. Just follow these simple steps and if you need any more information you can contact us: at Australia: 1800 666 078 Monday to Friday between 8:00am and 6:00pm AEST. New Zealand: 0800 522 663 Monday to Friday between 8:00am and 5:00pm NZST or email: info@kaboodlegroup.com.au.
- Clean your cabinets with an all purpose, non-abrasive cleaner with a damp sponge or cloth and make sure you never use saturated cloth, harsh chemicals or thinner-based cleaners as these will damage the surface of the melamine. Likewise, never use products that will scratch the surface like steel wool or wire brushes and avoid sharp objects that will scratch, cut or gouge the melamine surface. If this happens the internal board will be exposed and may swell. Kaboodle cabinets are water resistant but not water proof so any spills should be attended to immediately.
- Handy hint: if the melamine surface of your cabinet is damaged you can try and cover it with a furniture repair crayon but just remember that this won’t seal the board back to its original finish.
We offer a dedicated customer service line for advice or any questions you may
have on kaboodle products.
Call customer service on:
Australia: 1800 666 078 Monday to Friday between 8.00am and 6.00pm AEST
New Zealand : 0800 522 663 Monday to Friday between 8.00am and 5.00pm
NZST or email: info@kaboodlegroup.com.au
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>