WALI GMF003 Triple Monitor Mount Instruction Manual

INSTALLATION MANUAL
Triple Monitor Mount

GMF003 Triple Monitor Mount

GMF003| | |
---|---|---|---

WARNING!

If you do not understand these directions, or if you have any doubts about the safety of the installation, please call a qualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation may  cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual. Do not exceed weight capacity. We cannot be liable for damage or injury caused by improper mounting, incorrect  assembly or inappropriate use.

TIPOVER WARNING
SERIOUS OR FATAL CRUSHING INJURIES CAN OCCUR FROM TIPOVER.
TO HELP PREVENT TIPOVER:

• NEVER ALLOW CHILDREN TO CLIMB, STAND, HANG, OR PLAY ON ANY PART OF MONITOR OR STAND.
• USE TIPOVER RESTRAINT OR ANCHOR STAND TO WALL.

USE OF TIPOVER RESTRAINTS MAY ONLY REDUCE, BUT NOT ELIMINATE RISK OF TIP OVER.
SMALL PARTS- NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.

Supplied Parts List

Step 1
Tear off the protect paper to attach Anti-Skid Pad n to the bottom designated position of Base b as image shown.
Step 2
Install the Lower Pole a1 to the Weighted Base b using M5x14 Bolts f and corresponding M5x8 Bolts g , and tighten using the Allen Key o .
Step 3
Loosen the screw on the Lower Pole a1 with Allen key 2mm o . Connect Lower Pole a1 to Upper Pole a2 and tighten the screw with Allen key 2mm o to fix the two poles.
Step 4
Put the Wire Clip l and Arms c & d through the Poles a1 & a2, adjust the preferred height and tighten using Allen Key 6mm o . Attach the Wire Clips m to the Arm c .

Step 5

Step 6
Put the assembled TV/Monitor onto the Monitor Arms c & d and tighten the VESA Plate e with M6 Nut h for stability.
Step 7
If one monitor is lower, remove the Nut h and turn the bolt counter- clockwise using Allen key 3mm o to raise the monitor. Tighten the VESA Plate e with Nut h for stability after the adjustment.
Step 8
Manually swivel, tilt, and rotate the monitor for the best viewing angle. Guide the cable through the clip holder and store the Allen Key o in the holder.
Notice: Please make sure the M6 nut h is installed before you rotate the monitor.

support@walielectric.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>