air choice HD983-R7Q Oil Filled Radiator Heater User Manual

HD983-R7Q Oil Filled Radiator Heater

Operation Instruction for Oil Filled Radiator

INSTRUCTION MANUAL
1500W Portable Oil Filled Radiator Heater
Model# HD983-R7Q 120V 60Hz 1500W
READ AND SAVE THESE INSTRUCTIONS
READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE,INSTALL,OPERATE OR MAINTAIN THE PRODUCT DESCRIBED PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION.
FAILURE TO COMPLY WITH INSTRUCTION COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE.
RETAIN INSTRUCTIONS FOR FUTURE REFERENCE
IF YOU HAVE ANY QUESTIONS, PLEASE CONTACT US AT AIRORIGSERVICE@163.COM FOR HELP.

IMPORTANT INSTRUCTIONS

When using heater, basic precautions should always be followed to reduce the risk of fire, electric shock, injury to persons, and hyperthermia, including the following:

1. Read all instructions before using this heater.
2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. If provided, use handles when moving this heater. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9 m) from the front of the heater and keep them away from the sides and rear.
3. Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating and unattended.
4. Always unplug heater when not in use.
5. Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped or damaged in any manner. Discard heater, or return to authorized service facility for examination and/or repair.
6. Do not use outdoors.
7. This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never locate heater where it may fall into a bathtub or other water container.
8. Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Do not route cord under furniture or appliances. Arrange cord away from traffic area and where it will not be tripped over.
9. To disconnect heater, turn controls to off, then remove plug from outlet.
10. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater.
11. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a bed, where openings may become blocked.
12. A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint, or flammable liquids are used or stored.
13. Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons.
14. Always plug heaters directly into a wall outlet/receptacle. Never use with an extension cord or relocatable power tap (outlet/power strip).
15. SAVE THESE INSTRUCTIONS
16. Hyperthermia can result in death. Symptoms of hyperthermia include high body temperature, headache, nausea, vomiting, tiredness, dizziness, fainting, and rapid pulse. If you begin to experience symptoms related to hyperthermia, turn off the heater and seek medical attention.
17. To avoid excessive room temperatures which can cause hyperthermia: DO NOT leave product running unattended in a confined space around infants, or individuals with reduced physical, sensory, or mental capabilities.

USING YOUR HEATER

Thank you for choosing our heater please read this instruction carefully before operating and keep it for future reference.

Product characteristics

• Our electrothermal warmer operates as follows: tubular element is taken as heat source, efficient and permanent heat conduction oil is taken as the medium, heat eliminates via radiation fin, room temperature is increased via air circulation.
• Our electrothermal warmer has the following advantages: convenient, safe, beautiful, tranquil operation, without electromagnetic disturbance etc. It is suitable for such locations as scientific research room, hospital, hotel, training practice house, and bedroom, etc. The warmer keeps your room or office more comfortable in cold seasons!

Product structure diagram

Product Accessories

Operation instruction

Mounting:
Take out the heater and all the parts from packing carton;

1. The heater should be unplugged during assembly or disassembly
2. For ease of assembly turn the unit upside down.
3. Place the footplate on the top of both radiation fins;You’d better refer to the product structure diagram, seeing the wheels location between the first and last set of fins;
4. Fix the footplate on the heater with specified U type bolt and wing nut,tighten the screw;
5. After assembly is complete, turn the unit wheel side down for operation

Note: Do not operate without wheels attached. Operating:

1. Do ensure the temperature knob and power setting knob are at MIN position before using and plug the power cord into a wall outlet (120VAC, 60Hz);
2. When the unit is turned on, the power indicator light will illuminate to tell you that the heater is functioning;
3. The temperature knob can regulate room temperature. Turn the temperature knob clockwise to increase the temperature; turn it anti-clockwise to reduce the temperature until appropriate temperature is reached, the indicator “ON”.
4. “I” – Low Heating (600 Watts)
   “II” – Medium Heating (900 Watts)
   “III”– Maximum Heating (1500 Watts)

Circuit Diagram:

3. When you don’t use the heater, please rotate the power setting knob to 0 position, turn the temperature knob into the minimum position and plug off.
Note: the warmer operates via heat elimination of heat conduction oil, and the oil cools out slowly after the warmer is turned off, so do not move the warmer unless the oil has cooled out, and move the warmer with the handle.
NOTE: The product may emit an odor during first use; this is normal. Ventilate the area as needed.
During Season Care:

1. Before cleaning, be sure to turn off and unplug the heater.
2. Carefully wipe the unit with a soft damp cloth. Please be very cautious near the motor and heating elements.
3. Do not immerse the heater in water.
4. Never use gasoline, benzene or thinner. This will damage the surface of the heater.
   After cleaning, be sure to completely dry the unit with a cloth or towel.

Note: Do not use waxes or brush polish, since these will react with the heater, resulting in discoloration.
After Season Care:

1. Store heater in a cool and dry location with power cord properly secured.
2. Please store the unit in its original carton or suitable container.

Note: Do not disassemble radiation fin. Do NOT attempt to repair or adjust any electrical or mechanical functions on this unit.
Do not remove knob parts from the heater.

Technical parameters

Troubleshooting

The following troubleshooting guide addresses the most common problems. If your problem is not listed or still persists, please contact our Customer Support at AIRORIGSERVICE@163.COM.

plug to a powered electrical outlet.
Overheat Protection has been activated.| Turn the heater OFF, unplug it and allow it to cool.
Check and remove any objects on or adjacent to the heater.
Wait 5-10 minutes before plugging the unit back in.
No power is passing through the unit.| Ensure that your circuit breaker or fuse is working properly.
Ensure your heater is placed on a flat and even surface.
The set temperature is lower than the ambient temperature.| Make sure the thermostat is set at a higher temperature than the ambient temperature.
The heater suddenly stops during heating| The temperature exceeds the threshold of the thermal cut off.| Turn off the unit and unplug it from the power outlet. Allow it to cool, and then plug it into the electrical outlet again.
The heater is tipped over.| Place it on a flat, level and stable surface.

Before Calling for Service

Q: What are the measurements of the heating unit?

A: The heater is 350x240x600mm(13.8x9.5x23.7inch) and weight is

Q: Do I need to refill the oil heater or change the oil?

A: The oil in our oil filled radiators is there for the life of the product. There is no need to change the oil or refill it.

Q: How long is the cable on the Air Orig Filled heaters?

A: The cable is 1.8m / 6 feet long.

Q: What type of oil is used in your oil filled radiators?

A: The oil filled radiators are filled with diathermic heat transfer fluid. This will not need replacing within the product's lifetime.

Q: What are the power settings on my oil filled radiator?

A: The heating power settings on the 1500 Watt heater are: Min - 600W Med - 900W Max - 1500W

Q: How much does it cost to run my heater?

A: 1) It is very difficult to actually determine how much it costs to run a heater within your own environment. It depends largely on the type of house, size of room, and quality of insulation. 2) However, the maximum heater will cost per 1 unit of electricity per hour, per kilowatt of heat. For example, if you have a 1200W heater, the maximum it will use is 1.2 energy units per hour. Oil filled radiators are more economical to run because they retain heat longer and power demand through the temperature control is called upon less frequently. Electric heaters heat only the room you are in and not the entire house, providing extra heat only where required and helping to optimize energy consumption. 3 ) Electricity costs vary across suppliers. If you check your bill, you will be able to find out how much you are paying per unit of electricity.

1 YEAR LIMITED WARRANTY

The manufacturer warrants that your new electric heater is free from manufacturing and material defects for a period of one y ear from date of purchase, subject to the following conditions and limitations.

1. Install and operate this electric heater in accordance with the installation and operating instructions furnished with the product at all times. Any unauthorized repair, alteration, willful abuse, accident, or misuse of the product shall nullify this warranty.
2. This warranty is non-transferable, and is made to the original owner, provided that the purchase was made through an authorized supplier of the product.
3. The warranty is limited to the repair or replacement of part(s) found to be defective in material or workmanship, provided that such part(s) have been subjected to normal conditions of use and service, after said defect is confirmed by the manufacturer’s inspection
4. The manufacturer may, at its discretion, fully discharge all obligations with respect to this warranty by refunding the wholesale price of the defective part(s).
5. Any installation, labor, construction, transportation, or other related costs/expenses arising from defective part(s), repair, replacement, or otherwise of same, will not be covered by this warranty, or shall the manufacturer assume responsibility for same.
6. The owner/user assumes all other risks, if any, including the risk of any direct, indirect or consequential loss or damage arising out of the use, or inability to use the product, except as provided by law.
7. All other warranties ­ expressed or implied ­with respect to the product, its components and accessories, or any obligations/liabilities on the part of the manufacturer are hereby expressly excluded.
8. The manufacturer neither assumes, nor authorizes any third party to assume on its behalf, any other liabilities with respect to the sale of the product.
9. The warranties as outlined within this document do not apply to non accessories used in conjunction with the installation of this product.
10. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.

This warranty is void if:
a. The heater is subjected to prolonged periods of dampness or condensation.
b. Any unauthorized alteration, willful abuse, accident, or misuse of the product.
c. You do not have the original receipt of purchase.
Our message centers are available 7 days a week 24 hours a day at our toll- free help line.
Our Consumer Service department is available Monday ­ Friday 8:30 am ­ 5:30 pm EST.
If you have any questions, please contact us at airorigservice@163.com for help, we will solve it for you within 24 hours.

IMPORTANT: Before contacting Customer Service please have this information available:

• Serial Number
• Model Number
• Sales Receipt or Proof of Purchase

ATTENTION:

1. Please check the manual carefully and make sure you have received all the parts.
2. If there is any missing,please let us know the letter of the parts you need.
3. If there is any damage,please send clear photos to us, we will check and offer you best solution soon.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>