breo iSeeM Eye Massager with Heat and Air Pressure User Guide

breo iSeeM Eye Massager with Heat and Air Pressure.

Thank you for purchasing Breo! Please read this user’s manual carefully prior to use and, keep it properly for future reference.

Caution

Note: To ensure safety in operation, please read the Use Instruction Manual carefully prior to operation. The Company should not be liable for the consequences of improper use or non­compliance with the instructions for the product.

1. Do not use the product when driving a vehicle.
2. Prior to operation, remove the jewelry or articles that may affect the massage from the body part to receive a massage.
3. Do not use the product in a humid environment such as a bathroom.
4. Please keep the product away from the water source, source of ignition, and corrosive environment.
5. Observe safety regulations when you use the product in a specific environment.
6. Do not use the massager on body parts subjected to a surgical operation.
7. Do not use the massager on body parts suffering from a skin injury, swelling, inflammation, or blood stasis.
8. Those with heart disease or a history of heart disease, acute disease, skin disease, malignant tumor, or physical abnormality should not use the product.
9. Those with blood disease showing bleeding tendency, osteoporosis, soft tissue disease, and apoplexy should not use the product.
10. Those with leaden feet, physical and mental illness or mental retardation should not use the product and should follow the doctor’s advice if they need to use it.
11. If you have any discomfort during use, stop using the product.
12. Pregnant women and menstrual women should not use the massager.
13. Children under 6 years of age are prohibited from using the product, and children aged 6-12 can use the product only when they are subject to guidance and care from their parents or supervisors.
14. To clean the appearance, use alcohol and cotton instead of water.
15. Do not scratch or stab the product using a sharp object.
16. This product is a domestic electronic healthcare product. The product is not designed to work as a medical device, and it does not apply in diagnosis, treatment and other commercial uses.
17. Never fail to charge the product using charging equipment provided by the Company. Pay attention to electrical safety.
18. Once any exception occurs during operation, power off the product immediately. Please do not disassemble, reassemble and repair the product without consent.

Product Configuration

Massager, charging cable, storage bag, and instruction manual

Product Characteristics

Product Functions

1. Wearing:
   Adjust the belt to comfort Position;

2. PowerON:
   Hold the ‘Power’ button until a beep Sound Comes out;

3. Mode selection:
   Press the mode selection button to select between MED, HARD and SOFT;

4. Music:
   With the device connected, music can be Transmit through the Bree APP;

5. Power OFF:
   Hold the ‘Power’ button again until the Beep Sound come out;

6. Battery:
   When the product is underpowered, the electricity indicator starts to flicker;

7. Charging:
   The electricity symbol flashes during Charging, and full Charging the electricity symbol is on.

Troubleshooting

If a fault occurs during operation, do check it. In case the fault cannot be eliminated, or the product still fails to work satisfactorily, please turn off the massager and ask a professional technician to repair it. Please do not disassemble the product without consent!

Basic fault

|

Possible cause

| Basic troubleshooting method
---|---|---

Failure to start up

| Check whether the battery level is low| If yes, please charge in

time

Low massage strength

| Check whether the battery level is low| If yes, please charge in

time

Protection

Storage
To use the machine when a storage period of over 3 months expires, never fail to perform an open-case inspection and recharge it. Never allow the machine to abut against the floor, wall, and roof when you place it. The room should be well ventilated, without intense sunlight exposure and corrosive gas erosion.

Transportation
The product package with simple anti-vibration functions applies in air, railway, highway, and ship transportation, and should be protected from rain, snow, splash, inversion, and collision.

Power Check
Check the power supply. If the supply voltage exceeds the specified range, the machine should not be turned on.

Maintenance
Damp-proof, anti-mouse, and anti-pollution measures should be taken. The machine shall be shut down before it is cleaned. Place the product in a safe place after use, and do not put any heavy object on it. The machine shall be repaired by a professional technician in case any fault occurs. The non­professional are not allowed to disassemble and reassemble the product without consent.

Abandonment and Recovery
This product should not be discarded along with the household waste. Please follow local environmental laws and guidelines when you decide to dispose of the product.

Product Information

• Product name: Breo iSee M
• Model: see m1
• Voltage: SV=
• Power:SW
• Battery: 1150mAh
• Net weight: 300g
• Dimensions: L210mm x W75mm x H110mm

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>