CANARMNA IPL708B01 Pendant Light Instruction Manual

: June 14, 2024
: CANARMNA

Table of Contents

IPL708B01 Pendant Light
INSTALLATION
Read User Manual Online (PDF format)
Download This Manual (PDF format)

INSTRUCTIONS

IPL708B01 Pendant Light

**‘ PENDANT LIGHT**
Questions or Concerns Contact At The Following Phone Numbers Before Returning Product To The Store: 1-800-265-1833 (English) / 1-800-567-2513 (French) Monday through Friday 8:00 AM to 5:00 PM E.S.T. IPL708B01 05/20

INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS
READ ALL INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS

TOOLS AND MATERIALS REQUIRED:

Wiring supplies as required by local electrical code

SAFETY PRECAUTIONS:

TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
CONNECT THE GROUND WIRES (BARE COPPER OR GREEN) FROM YOUR FIXTURE TO THE GROUND WIRE (BARE COPPER OR GREEN) OR GROUND SCREW IN THE ELECTRICAL BOX.
TO CLEAN THE FIXTURE, TURN OFF THE POWER, WAIT FOR IT TO COOL, AND WIPE THE FIXTURE WITH A CLEAN, SOFT CLOTH.

NOTE : Product may not look exactly as shown in figures.

INSTALLATION

Screw the stem to the fixture.
Position the cover in place and screw the loop onto the stem.
Determine the height that you would like to hang your fixtureTrim the cord and chain. Allow 10” of extra wiring for the electrical box connections.
Loosen the upper connector from nipple. Attach the mounting bracket to the electrical box using electrical box screws. Attach the nipple to the mounting bracket and adjust until it will clear the canopy when assembled (Place the canopy over the nipple and
tighten the upper connector onto the nipple until snug. The upper connector should hold the canopy snug to the ceiling). Lock the nipple in the correct position using the hex nut.
Connect the chain to the loop and the top loop on the upper connector using the two screw hook.
Seal the opening on the screw hook by screwing the nut.
Loosen the nut on the upper connector and slide it down the chain towards the lower loop. Slide the canopy down the chain towards the lower loop. Feed the wire through nut, canopy, the upper connector and onto the nipple.
Tighten the upper connector onto the nipple.
Connect the ground wires (bare copper or green) from the fixture to the ground wire (bare copper or green) or ground screw in the electrical box. Connect the black wire (or wire marked “SPT-1”) from fixture to the black wire in the electrical box and connect the white wire (or the wire with ribbed side) from fixture to the white wire in the electrical box.
Once connections of wires are completed, carefully tuck wires and wire nuts into the electrical box making sure no bare wire (on the black and white) is visible at the wire nuts.
Slide the canopy up the chain and over the upper connector. Slide the nut up the chain and thread onto the upper connector.
Install specified bulb type and wattage (not included).
Screw glass shade on to the fixture.