SIGOR Numotion Rechargeable LED Table Lamp Instruction Manual
- June 1, 2024
- SIGOR
Table of Contents
SIGOR Numotion Rechargeable LED Table Lamp
Specifications
- Brand: Numotion
- Model: LED battery table lamp
- Features: touch switch, dimmable, FlexMood
- Ingress Protection: IP54 (splash-proof)
Product Usage Instructions
Intended Use
This product is designed for lighting purposes only. Avoid exposing it to
heavy mechanical loads or strong pollution.
Cleaning Instructions
Use a mild soap solution for cleaning and protecting the lamp from
aggressive atmospheres.
Initial Setup
- Remove the protective cover before the first use.
- Fully charge the battery.
Charging Instructions
The indicator light at the top will be red during charging and turn off when fully charged.
Operating the Lamp
- First touch: Switch on the luminaire with 2,700K warm white light.
- Second touch: Switch to 2,200K extra warm light.
- Third touch: Switch off the luminaire.
- Press and hold the touch switch to adjust light intensity gradually.
Additional Notes
Use only the provided power supply for charging.
WHAT IN BOX
DIMENSION
Instructions for use
Use purpose
This product is meant to be used for lighting only. It must not be exposed to
heavy mechanical load or strong pollution. The lamp is splash-proof according
to ingress protection code IP54. Clean only with mild soap solution, protect
from an aggressive atmosphere.
Technical Specification
- Power: 2.2 W
- Voltage: DC 3.7 V
- Luminous flux: at 2,200 K 140 lm, at 2,700 K 160 lm
- Luminous color: 2,200 K and 2,700 K
- CRI: 85
- Number of LED: 24
- Rechargeable battery: Li-ion,4,400 mAH
- Charging time: ~6 h
- Battery life: up to 12 h
- Protection class IEC: III, SELV
- Ingress protection code: IP54, splash water protected
- Ambient temperature: –20 up to +40 °C
- Dimmable: Yes, max. 20 %
Charger
- Input: 100–240 V ~, 50/60 Hz
- Output: 5 V, 1 A
- Length of cable: 1.2 m
Use instructions
- Before first use, please remove the protective cover and fully charge the battery.
- When charging, the indicator light at the top is red. When fully charged, it turns off.
- With the first touch of the touch-switch, you switch the luminaire on with 2,700 K warm white. With the second touch, you switch the light color to 2,200 K extra warm. With the third touch, you switch the luminaire off again.
- Press and hold the touch switch to gradually increase the light intensity. After four seconds, the light has reached its full light intensity. Press and hold the switch again to lower the light intensity again.
Important notice
- The support surface for the lamp must not exceed a 15° tilt or it will fall.
- The battery has an overcharge protection and can be replaced.
- In case of need of repair, return to your local dealer.
- Only use the supplied power supply unit for charging!
- The old device and battery must be disposed of separately from household waste. Please observe the disposal instructions in your city or municipality.
SCANNER
Sigor Licht GmbH
- Eichenhofer Weg 81, 42279 Wuppertal, Germany
- phone +49 2339 1261-0
- www.sigor.de,
- info@sigor.de
11/2023 Rechte und Änderungen vorbehalten
FAQ
- Q: What should I do if the lamp is not turning on?
- A: Make sure the lamp is fully charged and try pressing the touch switch again to turn it on.
- Q: Can I use a different power supply for charging?
- A: No, only use the power supply provided with the lamp for charging to avoid any damage.