bonsaii C149-C 18 Sheet Cross Cut Shredder Instruction Manual
- June 15, 2024
- Bonsaii
Table of Contents
bonsaii C149-C 18 Sheet Cross Cut Shredder
Thanks for choosing Bonsaii shredder!
Due to the resources of logistics and ocean shipping becoming tighter in the
whole world, the prices appear to be more expensive. To control the rise of
cost and provide your goods with cost-effective performance, we invite you to
follow the below Installation Instructions to prepare the shredder before use.
If you find there are any defective with the shredder or need any help, Please
kindly contact our customer service by email: customer-
care@bonsaii.com.
We will be there to assist right away.
INSTALLATION
-
Place the shredder on a flat and stable surface place and open the package.
-
Take the head of the shredder out of the basket of the shredder and place the head bottom up on the removed poly dragon.
CAUTION * when taking out the head of the shredder, please be careful of the sharp edges with the inside blades or the lock catch on the shredder’s body to avoid injury. -
Take out the shredder’s body with the basket together from the package to a flat and stable surface place.
-
Take out of the basket from the shredder’s body.
-
Install the trash can: align the body of the shredder with the body of the shredder, and then press down after the body of the shredder is aligned with the head of the shredder (please do not use too much force to avoid damaging the body of the shredder or the head of the shredder).
CAUTION *When installing the shredder’s head, your fingers don’t place the positions of the shredder’s head in connection with the shredder’s body to avoid injury.
-
Install shredder’s casters: Tip over the shredder’s body with a basket on a flat and stable surface place, casters aim at caster holes and press down.
CAUTION *Please don’t overexert and damage the shredder’s body.
-
Put the basket of the shredder on the body of the shredder to close it, and then check whether it is well installed around the shredder and whether the clearance between the nose and the body is no more than 0.08 (2mm) inches.
-
Plug in and move the “control panel” to Auto, the power light is in red (finish the Installation ).
CAUTION *lf the power light doesn’t work after you have installed the shredder, Maybe it hasn’t been installed well,try to repeat the operations from steps (7) to (8)
If there are still some problems with the shredder or need any help, Please kindly contact our customer service by email: customer- care@bonsaii.com. We will be there to assist right away.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>