Adexa KNGEP04 Commercial Double Pizza Oven Electric 2 Chamber 420×400 Mechanical Controls User Manual

Adexa KNGEP04 Commercial Double Pizza Oven Electric 2 Chamber 420×400

Mechanical Controls

Product Information

• Model : EP04

Thank you for choosing our company’s electric pizza oven. This user manual contains important information about the installation, operation, maintenance, and troubleshooting of the product. Please read this manual carefully to ensure optimal performance and avoid any unnecessary loss or damage.

Product Usage Instructions

Control Board Operation Instruction
Please refer to the control board operating instructions provided in the manual for detailed information on how to operate the oven.

Functions

• Heating up quickly : The oven is equipped with a 350 thermostat, which significantly reduces cooking time.
• Baking Stone : The oven is equipped with a baking stone that ensures even heating of food.
• Dual Thermostats: Two thermostats separately control the top and bottom heating elements, allowing you to adjust the temperature of each heating element as desired.

Application

• Baking : The oven is suitable for baking all types of fresh and frozen bread and flour products.
• Meat Baking : The oven can also be used for baking fresh and frozen meat.

Machine Illustration Diagram

Installation Instruction

1. All electrical power unit and circuit connections must be installed by a qualified electrician following safety standards.
2. Connections must be made according to the requirements specified in the manual.
3. Ensure that the rubber feet of the oven have been securely installed.
4. Place the product in a well-ventilated area on a solid platform.

Operation Instruction
Please refer to the operation instructions provided in the manual for detailed information on how to use the oven.

Warning

• Before cleaning, repairing, or moving the machine, always pull out the plug to disconnect the power supply.
• Avoid touching the switch or plug with wet hands to prevent electric shock.
• Do not flush the machine directly with water. Take caution not to let any water flow into the switch during cleaning.
• Keep the machine out of reach of children.
• The ground wire must be properly connected, and all connections should be reinstated after maintenance.

Maintenance

1. Pull out the plug before performing any maintenance tasks and allow the chamber to cool down.
2. For daily cleaning, use a dry cloth to wipe off grease from the chamber. Do not flush the chamber with water directly. To clean the baking stone, remove it from the oven and use a fur brush to clean its surface. Rinse it with water and dry it thoroughly. Avoid using any cleanser on the baking stone as it may affect the flavor of the food.
3. We recommend having the machine maintained by a qualified electrician at least once a month.

Troubleshooting

1. Check whether the connection is loose.

2. Rotate the thermostat to your desired temperature.

3. Ensure that the power switch matches the specified
   parameters.

4. Contact the service center for repair suggestions.

Short circuit| Contact the service center for repair suggestions.
Internal light not working|

1. Pull out the plug and allow the chamber to cool down.
2. Replace the bulb with a new one.

Scorching smell appears| Contact the service center to check whether there is a short
circuit in the connections.

Control board operating instruction

1. Operating instruction of the EP03& EP04 control board.
   • The right switch is for controlling the internal lighting.
   • The left switch is for controlling all the heating elements, turn it on, then the thermostats can be used. The indicator lights turn off when the heating elements reach the set temperature. (If the power switch is “On”, the timer would be out of function. If you need to use the timing function, please first turn off the power switch, by now, the timer is also act as “power switch”.)
   • These two（or three） thermostats are separately control the top、middle and bottom heating elements and their indicator lights.
   • The timer can set up between 0~120min.

Functions

1. Functions
   • Heating up quickly. This oven is equipped with 350℃ thermostat, greatly save the cooking time.
   • Equipped with baking stone, which makes the food are heated more evenly. 1.3 Two thermostats separately control the top and bottom heating elements, you can freely adjust the temperature of each heating element.
2. Application
   • Applicable for baking all the fresh and freeze bread and flour products.
   • Applicable for baking fresh and freeze meat.

Machine illustration diagram

EP03

EP04

Installation instruction

1. All the electrical power unit and circuit connection must be installed by qualified electrician with safety standard.
2. Connection must be based on requirements.
3. Make sure the rubber feet have been installed securely.
4. Product should be place in a well ventilated place on solid platform, and we suggest to least at least 10cm space between the product and the wall or barriers. Also place the product away from combustible materials, and there should be a fire extinguisher equipped around.
5. Remove the packaging film off the surface.
6. The power wire should be connected according to safety standards. Make sure the voltage and frequency conform to the parameters. And please install a double pole switch before connection. When the voltage working, the voltage error should be under ±10%. (Product must be connected to ground.)
7. Connect the cable to the power supply fixed by using a screwdriver according to the connection diagram, then loosen the screw inside the power point, and plug in the cable, make sure the sheet copper compress the power line tightly. If the connection is incorrect, it may cause joint heating and burning off the power cord.

Operation instruction

1. Turn on the power supply.

2. The temperature of the oven can be adjusted between 0~350℃.

3. Turn the timer clockwise to the desired time, then the indicator light on and the heating element starts working, when it reaches the set temperature, the indicator light off. If the temperature is below the set temperature, the heating element will be automatically reheated and the indicator light on.

4. The internal lighting can help monitoring the baking process.

5. Cooking time depends on the amount of the food, the more the food had, the
   longer the time required.

6. Please turn off the power if not using.

Warning

1. If you want to clean repair or move the machine, please pull out the plug first.
2. Please don’t touch the switch or plug with wet hand.
3. The machine can’t be flushed directly, and please be careful don’t let any water flow into the switch when cleaning.
4. Keep the children from touching or using the machine.
5. The ground wire must be connected, all the connection must be reinstated after maintenance.

Maintenance

1. Please pull out the plug first before maintenance, and clean it after cooling down the chamber.
2. For daily cleaning, you can use a dry cloth to wipe off the grease on the chamber, don’t flush the chamber with water directly. For cleaning the baking stone, please take out the baking stone, use a fur brush to clean its surface, and rinse it with water then dry it. (Don’t use any cleanser to clean the baking stone, because the baking stone can strongly absorb the water, so that the cleanser would be absorbed at the same time, which may affect the flavor of the food.)
3. We suggest to maintain the machine by qualified electrician once in a month.

Trouble shooting

 | Stoppage| Solution|
---|---|---|---
 |

1. Please check whether the connection is loose.

|
**** Not heating up|

1. Rotate the thermostat to your needed temperature.
2. Please check whether the power switch is match up with the parameters
3. Contact the service center for repair suggestion.

| ****

Ⅸ

Short circuit| Contact the service center for repair suggestion| Speci ficati on
Internal light

Not work

|

1. Pull out the plug, and cool down the chamber.
2. Replace a new bulb.

 |
Scorching smell

appear

| Contact the service center to check whether the connection is short out.|
 | Readjust the thermostats for each heating elements to see how they work,|
Baking unevenly| If they work well, please contact the service center to check if the Heating|
 | element need to change.|
Model| Temperature range| Dimension(mm)| Internal dimension(mm)| Voltage(V)| Power(KW)
EP04| 0~350 ℃| 590X530X535| 420X400X160X2PCS| 220V| 3

Wiring diagrams

• ST1 ST2 ST3 – Thermostat
• L1 HI2 H3-Indicator light
• SA -Power Switch
• $1-Switch of the internal lighting
• R1 R2 R3 -Heating element
• PT -Timer
• HL. -Internal lighting

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>