OPT7 RV Class B Aura RV Underbody Installation Guide
- June 13, 2024
- OPT7
Table of Contents
AURA
UNDERGLOW
RV CLASS B/B+ FIT
INSTALLATION GUIDE
RV Class B Aura RV Underbody
COMPONENTS
INSTALLATION
STEP 1
Inspect kit to ensure all contents was included.
STEP 2
Decide where to locate the control box and ensure wiring has enough length for
light bars to be installed in desired location.
IMPORTANT
The control box must be installed inside the vehicle as it is not waterproof.
Avoid installation areas of the engine bay + heated surfaces .
IMPORTANT
The spare tire is usually located at the bottom of the car.
Please pay attention to the position of the spare tire of your vehicle after
installing the rear light bar. Please find a suitable place to install the rear
light bar to prevent the spare tire from being used normally.
EXAMPLES
HOW TO CONNECT POWER HARNESS TO YOUR VEHICLE
- Connect the Red Terminal (+) of power hareness to the vehicle battery’s positive terminal.
- Connect the Black Terminal (-) of power hareness to the vehicle battery’s negative terminal or an unpainted area on your vehicle’s frame.
WARNING
Please ensure the Underglow LED Bars / Control Box / Wirings are all mounted away from heated surfaces exceeding from 85C or 185F.
IMPORTANT
BE SURE TO CONFIRM THE CORRECT DIRECTION OF THE ARROW!! TO AVOID PRODUCT DAMAGE DUE TO INCORRECT INSTALLATION.
CORRECT INSTALLATION
STEP 3
Secure Control box in desired location with Velcro or zipties.
- CONTROL BOX NOT WATERPROOF
Ensure the control box is safely and securely hidden from exposing elements of moisture.
STEP 4
Secure the light bars using the zip ties to tie all the wiring away from the
moving components.
AUX WIRING FOR A DOOR/DOME LIGHT
Please scan to see a detail instruction on Door Assist Sync or go to https://wintis.ladesk.com/549690-AURA-Door-AssistAUX-Installation-Guide
Using the included E-Z Remote, select your desired color or pattern.
OPTION METHOOD
To power the kit using an switched 10 AMP fuse tap method, you may purchase
the AURA Universal Replacement Fuse Tap Adapter Set & Power Wire on our
website. (*Not included; sold separately.)
Feel free to contact us using the link below for product inquires or
installation support.
OPT7 SUPPORT TEAM: https://www.opt-7.com/pages/customer-support
WARNING
- Connecting to more than 10 AMP will override the kit and cause early failure, ensure it is 10 AMP or less !!
- Please ensure the Underglow LED Bars / Control Box / Wirings are all mounted away from heated surfaces exceeding from 85C or 185F.
DISCLAIMER
OPT7 Lighting is not liable for damages or personal injuries while installing
this product. The Installation Guide is intended as assistance to reduce setup
time. OPT7 Lighting assumes no responsibility for improper installation.
If you are unfamiliar with your vehicle or inexperienced with aftermarket
upgrades, please seek professional assistance.
OPT7 recommends installation for safety and guidance.
Modified installations or installation recommendations not specified by OPT7
Lighting will void product warranty.
References
- OPT7 - LED Lighting for Cars, Trucks & Motorcycles – OPT7 Lighting Inc
- Contact Us | Support Request Page - OPT-7.com – OPT7 Lighting Inc
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>