OPT7 Rock Lights 5 Pin On Off Rocker Switch Installation Guide
- June 13, 2024
- OPT7
Table of Contents
OPT7 Rock Lights 5 Pin On Off Rocker Switch
Product Information
The Rock Lights 5 Pin On/Off Rocker Switch with Jumper Wires is a lighting component designed for installation in vehicles. It comes with a rocker switch and jumper wires for easy connectivity.
Components:
- Rocker Switch
- Jumper Wires
Specifications
- Input Voltage: DC 12V
- Input Power: Max 2.4 Watts per pod
- LED Color Options: White, Blue, or Green
- Temperature Range: -5°C to 120°C
Product Usage Instructions
Installation:
-
1. Follow the wiring method as shown in the diagram:7 8 4 1 5 2 6 3 7 8 4 1 5 2 6 3
-
Find an appropriate place to install the Rock Lights.
Wiring Connections:
- Connect the black jumper wire to port 7 and port 8.
- Connect the red jumper wire to port 2 and port 6.
- Connect another red jumper wire to port 3.
Final Steps:
- Confirm all the ports are connected properly.
- Connect the ports to the corresponding wires.
Disclaimer:
If you are uncomfortable performing work of this nature yourself, do not hesitate to consult a professional for assistance. Working with a vehicle’s electrical system can be hazardous to an unqualified individual. OPT7 is not liable for any damages or personal injuries that may occur during the installation of this product. The installation guide provided is meant to reduce setup time but OPT7 assumes no responsibility for improper installation.
Please note that modified installations or installation recommendations not specified by OPT7 Lighting will void the product warranty. OPT7 recommends seeking professional assistance if you are unfamiliar with your vehicle or inexperienced with aftermarket upgrades.
ROCK LIGHTS 5 PIN ON/OFF
WITH JUMPER WIRES
COMPONENTS
SPECIFICATIONS
- Input Voltage: DC 12V
- Input Power: Max 2.4Watts per pod
- LED Color options: White, or Blue, or Green
- Temperature: -5℉ – 120℉
INSTALLATION
STEP 1
- Follow the wiring method :
- When the lower LED is on when Power on
- When the upper LED is on when the Switch is on.
STEP 2
Find an appropriate place to install it.
STEP 3
- Connect the black jumper wire to the ports 7 and 8.
- Connect the red jumper wire to port 2 and port 6.
- Connect the red jumper wire to the port 3.
STEP 4
Confirm all the ports are connected and then connect the ports to the wires.
DISCLAIMER
If you are uncomfortable performing work of this nature yourself, then do not hesitate to consult a professional for help. Working with a vehicle’s electrical system can be hazardous to an unqualified individual. OPT7 is not liable for damages or personal injuries while installing this product. The installation guide is provided as assistance to reduce set-up time.
OPT7 Lighting is not liable for damages or personal injuries while installing this product. The Installation Guide is intended as assistance to reduce setup time. OPT7 Lighting assumes no responsibility for improper installation. If you are unfamiliar with your vehicle or inexperienced with aftermarket upgrades, please seek professional assistance.
OPT7 recommends installation for safety and guidance. Modified installations or installation recommendations not specified by OPT7 Lighting will void the product warranty.