MOEN Y0924BN Graeden 24-in Brushed Nickel Wall Mount Single Towel Bar Instruction Manual
- June 13, 2024
- Moen
Table of Contents
MOEN Y0924BN Graeden 24-in Brushed Nickel Wall Mount Single Towel Bar
GraedenTM
Customer Service USA: 1-800-882-0116
International Customer Service:
1-440-962-2263
Website: www.moen.com
Product Information
Collection| Installation Instructions for 18 in. and 24 in. Towel Bars,
Pivoting Paper Holder, Robe Hook and Towel Ring
---|---
Tools Required| Phillips screwdriver, drill, 5/16 drill bit, hammer, level,
tape
Note| Directions below are for installation into drywall. If
installing product into a stud, use the wood screws only.
Hardware Kit Contents| 4 plastic toggle anchors, 4 wood/anchor screws, 1
plastic pin,
1 hex wrench, 2 anchors for single mounting
Don’t forget to register and review your product by visiting moen.com /product-registration.
Product Usage Instructions
Towel Ring
Single Robe Hook
Instruction
Collection: Installation Instructions for 18 in. and 24 in. Towel Bars, Pivoting Paper Holder, Robe Hook and
Towel Ring
Tools Required: Phillips screwdriver, drill, 5/16″ drill bit, hammer,
level, tape
Note: Directions below are for installation into drywall. If installing
product into a stud, use the wood screws only.
Hardware Kit Contents: 4 plastic toggle anchors, 4 wood/anchor screws, 1
plastic pin, 1 hex wrench, 2 anchors for single mounting
- Position the mounting template on the wall in the desired location.
- Using a level, align the template and tape it to the wall.
- Drill two 5/16″ holes at each mounting plate location that corresponds to your product.
- Remove the template from the wall.
- Fold ends of the plastic toggle anchor together (see Figure 1) and insert into each hole in the wall.
- Lightly tap anchors until flush with the wall.
- One at a time, insert plastic pin into each anchor and lightly tap to activate anchor (see Figure 2).
- Remove pin and repeat on all anchors.
- Remove mounting plates from the posts by loosening each setscrew.
- Place the mounting plate on the wall over the installed wall anchors with “UP” facing you.
- Insert screws through the mounting plate into the anchors. Tighten the screws.
- Place posts over the mounting plates with setscrew facing down and tighten setscrew
For Single Bracket Mounting Instructions:
- Position the mounting template on the wall in the desired location.
- Using a level, align the template and tape it to the wall.
- Drill two 5/16″ hole at mounting post location that corresponds to your product.
- Remove the template from the wall.
- Lightly tap anchor until flush with the wall.
- One at a time, insert plastic pin into the anchor and lightly tap to activate anchor.
- Remove mounting plates from the posts by loosening each setscrew.
- Place the mounting plate on the wall over the installed wall anchors with “UP” facing you.
- Insert screws through the mounting plate into the anchors. Tighten the screws.
Don’t forget to register and review your product by visiting moen.com /product-registration.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>