KUZCO WS10501 LED Lamp Wall Sconce Instruction Manual
- June 4, 2024
- KUZCO
Table of Contents
WS10501 LED Lamp Wall Sconce
Instruction Manual
START FROM HERE
- Make sure the power is completely off at the fuse box.
- Have your fixture installed by a qualified licensed electrician
- Prepare everything in a clear area.
- Wear gloves at all times during this installation.
- Read the instructions carefully before you start assembly.
- Keep this instruction sheet for future reference.
- Technical Support: 1-855-855-8926
LED Lamp Wall Sconce
Please Note:
- All Kuzco LED fixtures are to come with pre-wired LED module(s).
- Unless instructed to do so, please do not touch any part of the LED module(s) as any unnecessary contact with the module could cause permanent damage.
- For dimming, an ELV (Electronic Low Voltage) dimmer is required.
-
Remove the fixture from its original packaging.
Remove the mounting plate from within the canopy and attach it to the electrical junction box, and wall, using the two screws provided in the hardware package -
Attach the canopy to the junction box on the wall.
First attach all wiring (2a) with the provided markets (white to white “N”, black to black “L”, ground to ground “G”). Thread the screws (2b) through the canopy plate and tighten them into the mounting plate. Lastly, place the fixture (2C) onto the canopy plate and secure it with set screws (2D). -
You have now completed the installation of your fixture, please enjoy.
19054 28th Avenue Surrey, BC Canada V3Z 6M3
T: 604 538 7162
TF: 1-855 85 KUZCO F: 604 538 7196
W: kuzcolighting.com
20181127
Documents / Resources
|
KUZCO WS10501 LED Lamp Wall
Sconce
[pdf] Instruction Manual
WS10501, LED Lamp Wall Sconce, Lamp Wall Sconce, Wall Sconce, LED Lamp,
Sconce, WS10501
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>