FISHBONE OFFROAD FB22397 13 Current Dodge Ram Front Bumper Installation Guide
- June 13, 2024
- FISHBONE OFFROAD
Table of Contents
INSTALLATION INSTRUCTIONS
PART No. FB22397
13-Current Dodge Ram Front Bumper
FB22397 13 Current Dodge Ram Front Bumper
REQUIRED TOOLS | KIT CONTAINS | QTY |
---|---|---|
Die Grinder | Front Bumper | 1 |
18mm Socket | Nut Plate | 4 |
5mm Socket | M12 Nyloc Nut | 8 |
M12 Washer | 8 | |
Help of a friend | Plastic Washer | 8 |
Winch Plate | 1 | |
Flange Bolt | 2 | |
Flange Nut | 2 | |
Trim Accents | 2 | |
Small Nut Plate | 2 | |
Small Nyloc Nut | 4 |
-
REMOVE EXISTING BUMPER
Begin removing your vehicle’s existing bumper and grille. We show how to do this in another video over at www.fishboneoffroad.tv
Remove the sensors and sensor wiring harness. -
SETUP
Depending on the state of your vehicle, with your die grinder, grind out the show hole so that the included nut plates can slide through. In the back of the bumper, install 2 of the nut plates into the outboard bumper-to-frame brackets, and screw on the included plastic washers to help keep them in place. If applicable, install your sensors and wiring harness at this time.
Install your winch onto the winch plate. -
INSTALL THE BUMPER
With the help of a friend and the 4 of the included m12 nuts and washer, secure the bumper to the frame rails with an 18mm socket.
2137400
550 W. PINE LAKE RO., SUITE 2.
NORTH LIMA. OHIO 44452 330.423.6446
WWW.FISHBONEOFFROAD.COM
Documents / Resources
|
FISHBONE OFFROAD FB22397 13 Current Dodge Ram Front
Bumper
[pdf] Installation Guide
FB22397, FB22397 13 Current Dodge Ram Front Bumper, 13 Current Dodge Ram Front
Bumper, Dodge Ram Front Bumper, Front Bumper, Bumper
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>