Fishbone Offroad FB22079 Bullhead Rear Bumper Instruction Manual
- June 15, 2024
- FISHBONE OFFROAD
Table of Contents
**Fishbone Offroad FB22079 Bullhead Rear Bumper Instruction Manual
**
REQUIRED TOOLS
- 17mm Socket/wrench
- 19mm Socket/wrench
| KIT CONTAINS | QTY |
|---|---|
| Bullhead bumper | 1 |
| Nut plate | 2 |
| Chassis bracket | 2 |
| Lower bracket | 2 |
| D-ring | 2 |
| M10 hex bolt | 8 |
| M10 flat washer | 8 |
| M10 lock washer | 8 |
| M12 hex bolt | 10 |
| M12 serrated nut | 6 |
| M12 flat washer | 10 |
| M12 lock washer | 10 |
-
REMOVE YOUR FACTORY BUMPER
Remove your vehicle’s existing factory bumper. If equipped, also remove the vehicle’s existing factory nut plate. This will require removing the muffler bracket bolts and tank skid plate bolts. -
INSERT PROVIDED NUT PLATES
Insert the supplied nut plates, noting correct orientation as shown below.
Re-secure muffler and skid plate bolts to the new nut plate. -
INSTALL CHASSIS BRACKET
Using eight (8) M10 bolts, flat washers, and lock washers, loosely secure the two (2) chassis brackets to the vehicle.
Set your bumper onto the brackets and position it centered on the vehicle. Ensure both brackets are contacting the inside bumper brackets.
Remove the bumper and secure the brackets in the location you’ve identified as center.
- INSTALL YOUR BUMPER
Place the bumper back on the secured chassis brackets. Using the supplied M12 hardware, secure the bumper to the chassis brackets. Ensure the bumper is positioned parallel to the ground before tightening the hardware.
Install the two (2) lower brackets using M12 hardware. On either side, two (2) bolts will install into the previously installed nut plates, and one will be secured using a supplied M12 serrated nut.
-
INSTALL THE DRINGS
Install the supplied D-Rings. -
ENJOY YOUR NEW FISHBONE OFFROAD BULLHEAD REAR BUMPER!
550 W. PINE LAKE RD., SUITE 2, NORTH LIMA, OHIO 44452 330.423.6446 WWW.FISHBONEOFFROAD.COM
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>