FISHBONE OFFROAD FB25314 Rear Seat Hi Lift Jack Mount Instruction Manual
- June 13, 2024
- FISHBONE OFFROAD
Table of Contents
FISHBONE OFFROAD FB25314 Rear Seat Hi Lift Jack Mount
PACKAGE CONTENTS
REQUIRED TOOLS
8mm Socket
Ratchet
KIT CONTAINS
KIT CONTAINS|
QTY
---|---
Mount Brackets (Left & Right)
| 1ea
2” Hex Bolt|
1
1” Hex Bolt
| 2
Flat Washer|
3
Lock Washer
| 3
Wing Nut|
3
FITS UP TO 48” JACK
HI-LIFT JACK NOT INCLUDED
INSTALLATION INSTALLATIONS
-
PREPARE YOUR SEAT
Open your vehicle and lay/push down the rear seat.
Locate the seat rail bracket on each side, just below the seat belt hanger.
With an 8mm socket, remove the 3 bolts from each bracket, and set them aside to be used in the next step.
-
INSTALL THE BRACKETS
The mounting brackets are driver and passenger side specific, and can be identified by the shape of their mounting plates (See diagram).
Place the mounting bracket under the seat bracket so that it sits in between the vehicle body and the plastic seat bracket. Reinstall the seat bracket with the mounting bracket with the 3 bolts previously removed, with an 8mm socket.
-
INSTALL YOUR JACK
Begin installing your jack. The foot will be installed on the passenger side with the included 1” bolts, washers, and lock washers. Place the foot onto the bracket until the holes line up with one another. Push the hardware through the plate and foot and secure it with 2 of the included wing nuts.
Repeat this with driver side and the 2” bolt and washers, while setting either the bolt to length by sliding it through the rail, or by adjusting the length of the jack. -
ENJOY YOUR HI-LIFT JACK MOUNT
CUSTOMERS SUPPORT
550 W. PINE LAKE RD., SUITE 2, NORTH LIMA, OHIO 44452 330.423.6446
WWW.FISHBONEOFFROAD.COM
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>