FISHBONE OFFROAD FB22032 Jeep JK Wrangler Rubicon Steel Rear Bumper With LED Installation Guide
- June 15, 2024
- FISHBONE OFFROAD
Table of Contents
FISHBONE OFFROAD FB22032 Jeep JK Wrangler Rubicon Steel Rear Bumper With
LED
REQUIRED TOOLS
- 18mm Socket
- 18mm Wrench
KIT CONTAINS
- M12 x 120mm Hex Bolt
- M12 x 35mm Hex Bolt
- M12 Lock Washer
- M12 Flat Washer
- Nut Plate
INSTALLATION INSTRUCTIONS
- REMOVE YOUR FACTORY BUMPER Begin by removing your factory bumper.
- INSTALL YOUR BUMPER
Insert the nut plates into your Jeep’s frame rails.
WITH THE WEIGHT OF THIS REAR BUMPER, IT IS HIGHLY ADVISED TO HAVE HELP WHEN
INSTALLING THE BUMPER!
With the help from a second pair of hands, lift the bumper up to the frame of
the Jeep. Using a short 12mm bolt, lock washer, and washer, loosely fasten the
bumper brackets to your frame rail. Do not tighten yet, as you may need to
adjust the bumper when installing the long 12mm bolts near the hitch.
Once all four (4) short bolts are loosely in place, install the remaining four (4) bolts, lock washers, and flat washers, through your rear crossmember and into the rear bumper.
-
TIGHTEN ALL BOLTS.
-
MOUNT THE SUPPLIED D-RINGS
-
RUN YOUR WIRING
Wire your new LEDs to turn on with your reverse lights or to an AUX switch inside your Jeep.
NOTE:
We suggest using a relay if you want to tap into your reverse lights. We do not recommend powering your new LED lights from your factory reverse lights. -
ENJOY YOUR NEW FISHBONE OFFROAD BUMPER!
550 W. PINE LAKE RO., SUITE 2, NORTH LIMA, OHIO 44452 330.423.6446 WWW.FISHBONEOFFROAD.COM
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>