FISHBONE OFFROAD FB22089 Mako Rear Bumper Instruction Manual
- June 15, 2024
- FISHBONE OFFROAD
Table of Contents
FISHBONE OFFROAD FB22089 Mako Rear Bumper
OVERVIEW
REQUIRED TOOLS
- 18mm Socket
- 21mm Socket
KIT CONTAINS QTY
- Sensor Delete Plug 4
- Nut Plate 1
- M12 Bolt 2
- M12 Washer 2
- M12 Lock Washer 2
- D-Rings 2
INSTALLATION INSTRUCTIONS
REMOVE THE EXISTING REAR BUMPER
Remove the Factory or existing rear bumper, we suggest removing the spare tire
to aid in the installation of the new bumper. Keep this hardware as some is
re-used
REMOVE SENSORS (IF EQUIPPED)
If your Model has backup sensors carefully remove them in order, and make note
of where each sensor came from. If not equipped go to step #3
REINSTALL SENSORS INTO THE MAKO REAR BUMPER
Reinstall Sensors into the MAKO rear bumper, in the same location that they
were removed. If sensors are not equipped on your JL install the Sensor delete
plugs.
INSTALL NUT PLATE.
Insert the nut plate into the Passenger side opening of the frame and align it
with the first two bottom holes. This is only used on the passenger side.
PLACE THE BUMPER ONTO THE REAR CROSS MEMBER
WITH THE WEIGHT OF THE BUMPER IT IS HIGHLY ADVISED TO HAVE HELP WHEN
INSTALLING THE BUMPER.
With the help of a second pair of hands lift the bumper up to the Jeep and place it onto the rear frame cross member. Loosely secure the bumper by threading in two 21mm body frame bolts.
SECURE THE BUMPER.
With two M12 bolts secure the right side of the bumper using the nut plate.
Secure the remaining four 18mm body mount bolts
- RECONNECT THE SENSOR CABLES.
REATTACH SPARE TIRE.
Take care to properly torque the lug nuts onto the spare tire carrier
INSTALL D-RINGS
550 W. PINE LAKE SUITE 2. NORTH LIMA. OHIO 44452 330423.6446 WWW.FISHBONEOFFROALCOM
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>