FISHBONE OFFROAD FB22046 Manowar JK Rear Bumper Instruction Manual
- June 15, 2024
- FISHBONE OFFROAD
Table of Contents
FISHBONE OFFROAD FB22046 Manowar JK Rear Bumper Instruction Manual
Installation Instruction
-
REMOVE YOUR FACTORY BUMPER
Begin by removing your factory bumper. -
INSTALL YOUR BUMPER
Insert the nut plates into your Jeep’s frame rails. Ensure the plates are against the outer faces of the rails.
WITH THE WEIGHT OF THIS REAR BUMPER, IT IS HIGHLY ADVISED TO HAVE HELP WHEN INSTALLING THE BUMPER!
TIP: Use a floor jack to help lift your bumper into place and hold it while you make fine adjustments. With the help from a second pair of hands, lift the bumper up to the frame of the Jeep. Using a short 12mm bolt, lock washer, and washer, loosely fasten the bumper brackets to your frame rail. Do not tighten yet, as you may need to adjust the bumper when installing the long 12mm bolts near the hitch.
Optional: Install the two OEM bolts at the front of the bracket.
Once all side bolts are loosely in place, install the remaining four (4)
bolts, lock washers, flat washers, and hex nuts, through your rear crossmember
and into the bumper
- **TIGHTEN ALL BOLTS.
**
- **MOUNT THE SUPPLIED D-RINGS
**
- ENJOY YOUR NEW FISHBONE OFFROAD BUMPER!
Documents / Resources
|
FISHBONE OFFROAD FB22046 Manowar JK Rear
Bumper
[pdf] Instruction Manual
FB22046 Manowar JK Rear Bumper, FB22046, Manowar JK Rear Bumper, JK Rear
Bumper, Rear Bumper, Bumper
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>