MINKA LAVERY 1430 33 x 24 In Mirror In Brushed Nickel Instruction Manual
- June 13, 2024
- MINKA LAVERY
Table of Contents
MINKA LAVERY 1430 33 x 24 In Mirror In Brushed Nickel
Product Information
This product is a household mirror with the model number 1430. It is designed to be installed on a wall and comes with all the necessary parts for installation.
Product Usage Instructions
- Carefully unpack the new mirror and lay out all parts on a clear area. Ensure that no small parts necessary for installation are lost.
- Find a suitable height on the wall where you want to install the mirror. Mark the location for the wall anchors.
- Pre-drill holes on the wall at the marked locations. Insert the anchor (A) into each hole, then thread the screw (B) into the anchor.
- If there is no solid backing on the wall for the screw to mount to, weigh your mirror and use an appropriately sized hollow wall anchor according to the manufacturer’s instructions. Make sure to leave a section of the screw projecting out and do not thread the whole screw into the wall.
- Hang the hooks (C) at the back of the mirror onto the screws (B) that extend out from the wall.
- The mirror is now properly installed and ready for use.
Please refer to the Installation Manual for any additional information or details about cleaning and maintenance of the mirror to ensure its new appearance is maintained over the years. When cleaning, use only a soft brush or lint-free cloth to avoid scratching the finish.
INSTALLATION INSTRUCTIONS
- For MODEL#1430
FOR HOUSEHOLD USE ONLY, READ AND SAVE THESE INSTRUCTIONS
Please read the Installation Manual thoroughly. Clean the mirror
periodically to help maintain its new appearance over the years. Use only a
soft brush or lint-free cloth to avoid scratching the finish.
When you begin to install the mirror, please follow the steps below
- Carefully unpack the new mirror and lay out all parts in a clear area. Take care not to lose any small parts necessary for installation.
- Find a suitable height on the wall, and mark the location for the wall anchors. Pre-drill holes on the wall. Insert anchor (A)) then thread screw (B) into the anchor. If no solid backing on the wall for the screw to mount to, weigh your mirror, and use an appropriately sized hollow wall anchor. Follow the manufacturer’s instructions. Please leave a section of the screw projecting out, and do not thread the whole screw into the wall.
- Hang hooks (C) at the back of the mirror onto screw (B) which extends out from the wall.
- The mirror is now installed!
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>