ERAN BS07 Around Neck BT Speaker Instruction Manual

ERAN BS07 Around Neck BT Speaker Instruction Manual

Please confirm that the following accessories are included in the packing

box:

Please do not use if the device is partly damaged. Please contact distributors or after sales service of ERAN

Adjustable design

The speaker is flexible and can slight stretched to adapt to different neck sizes.

Waterproof

This speaker is IPX4 water waterproof and can prevent sweat.

Button and indicator Definition

key and indicator Definition

4: LED Indicator : Quick blinking in blue: Ready for Bluetooth paring, and goes off when pairing is successful. Led indicator will be lit in red while charging and will goes off when charging comp lete.

5: USB charging: For charging the device, connect the rated charger to charge.

6: Microphone: Used for Bluetooth-enabled calls.

Bluetooth connection

Press and hold button for 3 seconds to power-on the device, Device will automatically enter Bluetooth pairing mode and LED indicator blinks quickly in blue. User can use smart phone to search the paring ID “ER-BS07” for pairing.The device will prompt out “The Bluetooth device is connected successfully” and LED light goes off when paring is successfully.

Answering Call

After the device has been successful connected with a smart phone , when the phone gets an incoming call, the device will make ring tones.short press button for answering the call, short press button to hang up the phone during the phone conversation. Short press  button two times in a row to call back the last call/call number of the mobile phone made. When dialing is in process, short press button to cancel the call before the other party answer.

Charging Function

When the USB charging cable is plugged in, the Red charging indicator will turn solid .When the red light of the charging indicator is off, the charge is complete.

Technical Parameters

1. Input Charging Voltage and Current: SV/SOOMA
2. Battery Type: Built-in rechargeable Lithium battery
3. Battery Capacity: 3.7V/1000mAh
4. Speaker: 3W’2
5. F/R: 100HZ-20KHZ
6. SNR: 80DB
7. Bluetooth Version: Jerry VS.O
8. Working Range : lOM
9. Play time: 8 hours @ 60% volume

Name and composition of toxic or harmful substances or elements
Toxic or harmful substances and elements

This form complies with SJ/ tll364.
O: indicates that the toxic or harmful substances contained in all similar substances in this part are lower than the limit requirements in GB/ T26572.
X: Indicates that at least one of the same substances used in this part contains toxk or harmful
substances higher than the limit requirements in GB/ T26572.

ATTENTION:
With the software and hardware updated, all the technical data and the mode of operation showed on the manual could be changed without prior notice.

FCC Caution：
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>