ARDESTO HBSG-1000WHCHSL Hand Blender Instruction Manual

HAND BLENDER
Instruction manual

HBSG-1000WHCHSL Hand Blender

SAFETY MEASURES

Please read the instructions carefully and completely before using the appliance.

•  Always disconnect the appliance from the supply if it is left unattended and before assembling, disassembling or cleaning.

• This appliance shall not be used by children. Keep the appliance and its cord out of reach of children.

• This appliance can be used by children over the age of 8 and people with disabilities or lack of experience or knowledge, if they are under constant supervision or have been instructed in the safe use of the appliance and they understand the possible  angers. Cleaning and customer service should not be performed by children without supervision.

• Children shall not play with the appliance.

• Do not misuse the product, it may cause injury if misuse.

• Before plugging into a socket, check whether your voltage corresponds to the rating label of the appliance.

• Don’t plug the appliance into the power supply until it is fully assembled and always unplug before disassembling the appliance or handle the blade.

• Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions, or is dropped or damaged in any manner. Return the appliance to the nearest authorized service facility for examination, repair or electrical or mechanical adjustment.

• If the power cord is damaged, it must be replaced by the manufacturer, service center or similarly qualified personnel in order to avoid a hazard.

• Don’t let excess cord hang over the edge of the table or worktop or touch hot surface.

• The blades are very sharp! Handle carefully!

• Keep hands and utensils out of container while blending to reduce the risk of severe injury to persons or damage to the blender. A scraper may be used but must be used only when the blender is not running (does not apply to an acceptable scraper integral with the appliance.)

• To protect against risk of electrical shock do not put main unit, cord, or plug in water or other liquid.

• This appliance should not be used by children and care should be taken when used near children.

• Avoid contacting moving parts.

• Do not let cord contact hot surface, including the stove.

• Do not blend hot liquids.

• Neither the measuring beaker, nor the chopping bowl is microwave proof.

• Short – time operating (three times only). Use the appliance to operate soft food for no longer than 1 minute, and operate hard food for no longer than 15 seconds, operate 3 cycles for one use.

• To reduce the risk of injury, never place cutting blade on base without first putting bowl properly in place.

• Be certain cover is securely locked in place before operating appliance.

• Clean the hand blender with dry cloth.

• Care shall be taken when handling the sharp cutting blades, emptying the bowl and during cleaning.

• Do not touch any moving parts (blades, etc.). Switch off the appliance and disconnected from supply before changing accessories or approaching parts which move in use.

• Appliance is not intended to be used in the following applications, and the guarantee will not apply for:
  – staff kitchen areas in shops, offices and other working environments;
  – farm houses;
  – by clients in hotels, motels and other residential type environments;
  – bed and breakfast type environments.

• Do not use this appliance to blend or mix non-food items. Never run empty.

• Do not use accessories from the set (cups, jugs, bowls, etc.) as containers for freezing, heating or sterilization.

• Do not shake your appliance harshly during use.

• This product has been designed for indoor and domestic use only. Any commercial use, inappropriate use or failure to comply with the instructions, the manufacturer accepts no responsibility and the guarantee will not apply.

EQUIPMENT

Main unit – 1 pc
Blender attachment – 1 pc
Whisk – 1 pc
Chopper – 1 pc
Discs – 3 pcs
Dicer mesh attachment – 1 pc
Pusher – 1 pc
Cleaning pusher for dicer mesh – 1 pc
User manual (contains warranty card) – 1 pc

DEVICE DESCRIPTION

A – Main unit
A1 – Speed switch
A2 – ON/OFF switch (I)A3 – Turbo switch (II)
A4 – Release button
B – Blender attachmenC – Whisk holder
D – Whisk
E – Pusher
F – Bowl lid
G – Dicer knife
H – Dicer mesh attachment
I – Processing bowl
J – S-shape blade
K – Shredding/slicing disc
L – Grating disk
M – French fry disk
N – Driving shaft
O – Cleaning pusher for dicer mesh

HOW TO USE THE HAND BLENDER

The hand blender is perfectly suited for preparing dips, sauces, soups, mayonnaise and baby food as well as for mixing and milkshakes.

1. Insert the blender attachment onto the main unit until it locks.
2. Dip the blender attachment in the vessel. Then press the switch I or switch II.
3. Unplug then press the release button to remove attachment after use.

You can use the hand blender in the measuring beaker and just as well in any other vessel.
Caution! The blades are very sharp!

HOW TO USE THE WHISK

Use the whisk only for whipping cream, beating egg whites and mixing sponges and ready-mix desserts.

1. Inset the whisk into the whisk holder, and then slot the whisk holder onto the main unit until it locks.
2. Place the whisk in a vessel and only then press the switch I or switch II to operate it.
3. Unplug then press the release button to remove the whisk holder after use. Then pull the whisk out of the holder.

HOW TO USE THE CHOPPER WITH S-SHAPE BLADE

Attention! Do not chop very hard products, such as nutmegs, coffee beans and cereals.
Before you start chopping:

• Remove bones, sinews and cartilage from meat.
• Cut meat, onion, garlic, carrot etc. into approximately equal slices.
• When chopping greens, remove stems of herbs.

WARNING:

• Before assembling make sure that the power plug is not inserted into the socket.
• Do not overload the processing bowl!
• Caution: The blades are very sharp!

Usage:

1. Set the “S” blade on the axis of the processing bowl.
2. Put the products into the processing bowl.
3. Put the lid on the bowl.
4. Turn the lid clockwise to the position and check the fixation of the lid.
5. Put the main unit on the lid.
6. Insert the plug into the socket.
7. Set the required speed using the control.
8. To switch the blender on press and hold the button.
9. During operation hold the main unit with one hand and the bowl with the other hand.
10. After you finish using the unit, take the plug out of the socket, disconnect the main unit from the lid by press release button of the main unit.
11. Then remove the lid from the bowl by pressing the button and turning the lid anticlockwise.
12. Carefully remove the “S” blade from the processing bowl.
13. Clear, wash and dry all the used parts immediately after the end of operation.
14. Take the chopped products out of the processing bowl.
15. Put the “S” blade into a plastic protective cover.

Attention! Continuous operation time of the unit should not exceed 20-30 seconds.

HOW TO USE THE DISCS

Use the disks for fruits and vegetables.
Attention! Do not process hard and frozen food. It can damage the disks.
Warning: Before assembling make sure that the power plug is not inserted into the socket.

1. Set the driving shaft on the axis of the bowl.
2. Set the required disc on the driving shaft.
3. Put the lid on the bowl
4. Turn the lid clockwise to the position and check the fixation of the lid.
5. Put the main unit on the lid.
6. Insert the plug into the socket.
7. Set the required speed using the control.
8. To switch the blender on press and hold the button.
9. Place the products into the lid hole, use the pusher for products feeding. Press the pusher gently for products feeding.
10. After you finish using the unit, take the plug out of the socket, disconnect the main unit from the lid by press release button of the main unit.
11. Then remove the lid from the bowl by pressing the button and turning the lid anticlockwise.
12. Carefully remove the disc.
13. Take the chopped products out of the processing bowl.
14. Clear, wash and dry all the used parts immediately after the end of operation.

HOW TO USE THE DICER ATTACHMENT

Use the dicer attachment for cutting fruit and boiled vegetables.
Attention! Do not process hard and frozen food. It can damage the dicer attachment.
Warning: Before assembling make sure that the power plug is not inserted into the socket.

1. Fix dicer knife on dicer mech attachment.
2. Fix dicer mech attachment on processing bowl.
3. Put the lid on the bowl.
4. Turn the lid clockwise to the position and check the fixation of the lid.
5. Put the main unit on the lid.
6. Insert the plug into the socket.
7. Set the required speed using the control.
8. To switch the blender on press and hold the button.
9. Place the products into the lid hole, use the pusher for products feeding. Press the pusher gently for products feeding.
10. After you finish using the unit, take the plug out of the socket, disconnect the main unit from the lid by press release button of the main unit.
11. Then remove the lid from the bowl by pressing the button and turning the lid anticlockwise.
12. Carefully remove the dicer attachment and knife.
13. Take the chopped products out of the processing bowl.
14. Clear, wash and dry all the used parts immediately after the end of operation.

CLEANING AND MAINTENANCE

1.  Unplug the appliance before cleaning.
2. Cleaning the main unit and chopping bowl lid only with a damp cloth only. Do not immerse the main unit in water!
3. All other parts are washable. After processing very salty food, the blades must be rinsed immediately.
4. Regular clean surfaces in contact with food.
5. Be careful not to use an excessive amount of cleaner or descaling agent. Aggressive detergents may damage the part or change color.
6. When processing food with color, the plastic parts of the appliance may become discolored. Wipe these parts with vegetable oil before washing.
7. Please pay attention that blades are very sharp.
8. Before storing make sure the appliance is unplugged and cleaned and dry. Store the device in a cool, dry place.

The manufacturer reserves the right to make changes in the technical characteristics and design of the products that do not impair the operational qualities.

CORRECT DISPOSAL OF THIS PRODUCT

**** This marking indicates that this product should not be disposed with other household wastes. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources.
To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmental safe recycling.

Warranty conditions:

The plant guarantees normal operation of the product within 12 months from the date of the sale, provided that the consumer complies with the rules of operation and care provided by this Manual.
Service life of the product is 5 years.
In order to avoid any misunderstanding we kindly ask you to carefully study the Owner’s Manual, the terms of warranty, and check the correctness of filling the Warranty Card. The Warranty Card is valid only if the following information is correctly and clearly stated: model, serial number of the product, date of sale, clear seals of the companyseller, signature of the buyer.
The model and serial number of the product must correspond to those specified in the Warranty Card.
If these terms are violated, and if the information specified in the Warranty Card is changed, erased or rewritten, the Warranty Card is considered invalid.
Setup and installation (assembly, connection, etc.) of the appliance are described in the attached documentation; they can be carried out both by the user, and by specialists having the necessary qualification sent by USC or selling companies (on a paid basis). In this case, the person (the institution) installing the appliance shall be responsible for the correctness and quality of installation (setup). Please pay attention to the importance of the correct installation of the appliance, both for its reliable operation, and for
obtaining warranty and free service. Require the installation specialist to enter all the necessary information about the installation in the Warranty Card.
In case of failure of the appliance during the warranty period by the fault of the manufacturer, the owner is entitled to free warranty repair upon presentation of the correctly filled Warranty Card together with the appliance in the factory configuration packed in the original packaging to the warranty workshop or the place of its purchase. Satisfaction of the customer’s claim due to the fault of the manufacturer shall be made in accordance with the law «On Protection of Consumers’ Rights». In the case of warranty repair
the warranty period shall be extended for the period of repair and shipment.

WARRANTY CARD

Dear Buyer! Congratulations on your purchase of the ARDESTO brand appliance, which was designed and manufactured in accordance with the highest quality standards, and we thank you for choosing this particular instrument.
We ask you to keep the coupon during the warranty period. When purchasing a product, require a full warranty card.

1. Warranty service is carried out only if there is a correctly and clearly filled original warranty card, which indicates: product model, date of sale, serial number, warranty service period, and the seller’s seal. *

2. The service life of household appliances is 5 years.

3. The product is intended for consumer use. When using the product in commercial activities, the seller / manufacturer does not bear warranty obligations, after-sales service is performed on a paid basis.

4. Warranty repair is carried out within the period specified in the warranty card for the product in an authorized service center on the conditions and terms determined by applicable law.

5. The product is withdrawn from the warranty in case of violation by the consumer of the operating rules set forth in the instruction manual.

6. The product is removed from warranty service in the following cases:
   • misuse and non-consumer use;
   • mechanical damage;
   • damage caused by the ingress of foreign objects, substances, liquids, insects;
   • damage caused by natural disasters (rain, wind, lightning, etc.), fire, domestic factors (excessive humidity, dust, aggressive environment, etc.)
   • damage caused by non-compliance of power and cable network parameters with state standards and other similar factors;
   • when operating equipment in the power supply network with a missing single ground loop;
   • in case of violation of seals installed on the product;
   • lack of serial number of the device, or inability to identify it.

7. The warranty does not cover consumables and accessories, as well as filters, shelves, drawers, stands and other containers for storing products.

8. The warranty period is 12 months from the date of sale.

• Tear-off maintenance tickets are provided by an authorized service center.

The completeness of the product is checked. I have read the terms of the warranty service, no complaints. Customer Signature

Warranty card

Product information………………………….
Product………………………..
Model……………………….
Serial number……………………….
Seller Information………………………………..
Trade organization name…………………………………………
The address………………………………
Date of sale……………………………
Seller stamp…………………………………..
Coupon
Seller stamp
Date of application………………………………..
Cause of damage…………………
Date of completion…………………
Coupon2
Seller stamp
Date of application…………………………….
Cause of damage…………………………..
Date of completion……………………..
Coupon…………………………..
Seller stamp…………………………………..
Date of application……………………….
Cause of damage……………………..
Date of completion…………………………….

References

• Компания ERC: Сервис-центр(СЕРВІСНИЙ ЦЕНТР)

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>