Minka Lavery 821-695-L Velaux 6.5-in W 1-Light Soft Brass Modern-Contemporary LED Wall Sconce Instruction Manual
- June 13, 2024
- MINKA LAVERY
Table of Contents
INSTALLATION INSTRUCTIONS
Item#821-695-L (New. 2023/02/20)
READ AND SAVE THESE INSTRUCTIONS
**WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
**
MOUNTING THE FIXTURE (Fig.1)
-
Shut off power at the fuse box or circuit breaker box and remothe old fixture including the mounting hardware.
-
Carefully unpack your new fixture and lay out all the parts inclear area. Take care not to misplace any small parts necessfor installation.
-
Loosening screws (D) to remove mounting plate (A) from baplate (C).
-
Attach mounting plate (A) to the junction box (not includusing mounting screws (B). The side of mounting plate marked “GND” must face out.
CONNECTING THE WIRES (Fig. 2) -
Connect the electrical wires as shown in Fig. 2, making sure thatall wire connectors are secured. If your junction box has aground wire (green or bare copper), connect the fixture’s groundwire to it. Otherwise, connect the fixture’s ground wire directly tothe mounting plate (A) using the green screw provided. After thewires are connected, tuck them carefully inside the junction box.
FINISHING THE INSTALLATION (Fig.1) -
Place back plate (C) over mounting plate (A) and secure with screws (D).
Replacing LED module (Fig.3)
The LED module can be replaced by a qualified electrician without cutting of wire and without damage to any decorative element to which the fixture is attached. See installation steps for more details (Fig 3.)
a. Shut off the power.
b. To remove fixture from the wall, loosen screws (D) and back plate (C) from mounting plate (A). Disconnect wire connectors and place back plate (C) on a clean surface.
c. Loosening screws (E) and lock washers (F) to remove decorative frame (N) and white faux alabaster (M) from back plate (C).
d. Loosening screws (L) to remove plastic washers (K) and glass panel (J), and aluminum box (G) from back plate (C).
e. Press the button on printed “L” quick connector on LED module
(H) with screwdriver (not included) to disconnect the black wire.
Repeat by pressing the button on printed “N” quick connector on LED module (H) to disconnect the white wire.
f. Loosening screws (I) to remove LED module (H) from aluminum box (G)
g. Reverse steps b-f for installing the new LED module.
Note: Illustration (Fig. 1) on this manual is for installation purposes
only. It may or may not be identical to the fixture purchased.
Dimmable with ELV and/or LED compatible wall dimmer switches.
LA-3648E
Documents / Resources
|
Minka Lavery 821-695-L Velaux 6.5-in W 1-Light Soft Brass Modern-Contemporary
LED Wall
Sconce
[pdf] Instruction Manual
821-695-L Velaux 6.5-in W 1-Light Soft Brass Modern-Contemporary LED Wall
Sconce, 821-695-L, Velaux 6.5-in W 1-Light Soft Brass Modern-Contemporary LED
Wall Sconce, 1-Light Soft Brass Modern-Contemporary LED Wall Sconce, Brass
Modern-Contemporary LED Wall Sconce, LED Wall Sconce, Wall Sconce, Sconce
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>