FORTIN 102391 Suzuki Equator 2009 Standard Key Remote Starters And Alarm Systems Installation Guide
- June 13, 2024
- FORTIN
Table of Contents
102391 Suzuki Equator 2009 Standard Key
Remote Starters And Alarm Systems
Installation Guide
102391 Suzuki Equator 2009 Standard Key Remote Starters And Alarm
Systems
REV.: 20211104
Guide # 102391
REGULAR INSTALLATION
ADDENDUM – SUGGESTED WIRING CONFIGURATION
Vehicle functions supported in this diagram (functional if equipped)
VEHICLE YEARS
SUZUKI Immobilizer bypass
To add the firmware version and the options, use the FLASH LINK UPDATER or
FLASH LINK MOBILE tool, sold separately.
Parts required (Not included) 1x Relayed
This guide may change without notice. See www.fortin.ca for latest version.
WIRING CONNECTION
PROGRAMMING PROCEDURE 1/2
| Press and hold the programming button:
Insert the 4-Pin (Data-Connector) connector.
---|---
| Release the programming
button when the LED is YELLOW.
If the LED is not solid YELLOW disconnect the 4-Pin connector (Data-Link) and
go back to step 1.
| Insert the required remaining connectors.
| Press and release the
programming button two times (2x).
The YELLOW LED will alternate between 2x flashes and a pause.
Wait until the YELLOW
LED turns ON.
| Turn the Ignition to the ON/RUN
position.
The RED LED will turns ON.
| If the YELLOW and RED LED’s are not solid, remove the key and go back to
step 5.
Repeat this step until the RED and YELLOW LED’s are solid.
| Turn the Ignition to the OFF position.
| Remove the key from the ignition barrel.
| Turn the Ignition to the ON/RUN position.
The YELLOW and RED
LED’s will rapidly alternate.
When the YELLOW LED begins to flash rapidly: Key bypass programmed.
| Turn the Ignition to the OFF position.
The module is now programmed.
Use the remote of the remote starter or security system to test all of the
supported features to ensure proper programming.
www.fortinbypass.com
Module label
Notice: Updated Firmware and Installation Guides
Updated firmware and installation guides are posted on our web site on a
regular basis. We recommend that you update this module to the latest firmware
and download the latest installation guide(s) prior to the installation of
this product.
WARNING
The information on this sheet is provided on an (as is) basis with no
representation or warranty of accuracy whatsoever.
It is the sole responsibility of the installer to check and verify any circuit
before connecting to it. Only a computer safe logic probe or digital
multimeter should be used. FORTIN ELECTRONIC SYSTEMS assumes absolutely no
liability or responsibility whatsoever pertaining to the accuracy or currency
of the information supplied. The installation in every case is the sole
responsibility of the installer performing the work and FORTIN ELECTRONIC
SYSTEMS assumes no liability or responsibility whatsoever resulting from any
type of installation, whether performed properly, improperly or any other way.
Neither the manufacturer or distributor of this module is responsible of
damages of any kind indirectly or directly caused by this module, except for
the replacement of this module in case of manufacturing defects. This module
must be installed by qualified technician. The information supplied is a guide
only. This instruction guide may change without notice. Visit
www.fortinbypass.com to get the latest version.
TECH SUPPORT
Tel: 514-255-HELP (4357)
1-877-336-7797
ADDENDUM GUIDE
www.fortinbypass.com
WEB UPDATE
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>