Biocontrol HHR 5000 Device User Manual

June 5, 2024
Biocontrol

Biocontrol HHR 5000 Device User Manual

Safety devices

This system is designed to be safe to operate. The safety devices that are installed are there for personal safety and must not be modified, removed, or disconnected.

Any modification to the equipment’s original design may compromise the personal safety. Consequently, it may also void or limit the warranty.

Warranty

Note! BioControl will not take any responsibility for damage resulting from faulty operation, or for improper or inadequate care and maintenance.

Note! BioControl will not take any responsibility for any damage resulting from frost. The owner/user must take the necessary measurements to prevent the ambient temperature around the equipment from dropping to or below freezing point

Note! Modification may create risks not covered by the original construction. Do not make any modifications which has not been approved by BioControl.

Compliance with national regulations

FCC Compliance statement

This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment was tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

This device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. The radiation is below exemption level for handheld equipment. The antenna used for this transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Changes or modifications not expressly apporoved by the party responsible for compliance could void the user’s authority to operate the equipment.

ISED Compliance statement

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).

Operation is subject to the following two conditions:

  1. This device may not cause interference
  2. This device must accept any interference, including interference that may cause undesired operation of the device

Note! Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals