CLAS OM 8033 Inner Bearing Removal Set User Guide
- June 13, 2024
- CLAS
Table of Contents
OM 8033
INNER BEARING REMOVAL SET
WARNING
Before returning this product for any reason (installation problem, instructions for use, breakdown, manufacturing problem…), please contact us.
Contact :
You can reach us by mail sav@clas.com or by phone +33(0)4 79
72 69 18 or go directly to our website clas.com
If you have changed your mind regarding your purchase, please return this product before you attempt to install it.
COMPONENTS
1| GRIPPER Ø45-51 mm|
---|---|---
2| GRIPPER Ø40-45 mm|
3| GRIPPER Ø50-55 mm|
4| GRIPPER Ø56-61 mm|
5| CONICAL DRILL FOR SCREW|
6| GRIPPER Ø35-40 mm|
7| BODY EXTRACTOR|
8| EXTERNAL PART FOR BODY EXTRACTOR|
9| SCREW M22 – CH24|
10| ADAPTER M22 – 1″1/2 UN16 – CH41|
11| WRENCH Ø59,5 mm FOR BODY EXTRACTOR|
12| WRENCH Ø83 mm FOR 320022004|
APPLICATION
| VW | Mercedes |
|---|---|
| Audi | Opel |
| BMW | Renault |
| Ford | Peugeot |
| Fiat | Volvo |
INTRODUCTION
It is compulsory to read this instruction manual before starting any kind of action.
The proper operation and full compliance of this product’s performance is guaranteed only if all the instructions provided in this manual are closely adhered to.
We guarantee that this product complies with the technical specifications
described in this manual.
The manufacturer shall not be held responsible for any improper uses other
than those described herein.
Use protective work gloves, protective footwear, hard hat and safety goggles.
Misuse:
– This product should only be used as described in this documentation; any
other use is considered improper.
– The manufacturer accepts no responsibility for any damage caused by the
incorrect or unreasonable use of the equipment.
– Moreover, misuse shall also void the warranty.
Take care of your tools:
– Be sure to store your tools in a clean state.
– Place the tools inside their original package.
INSTRUCTION
Set of special tools suitable for the repalcement of inner ball bearings
This set allows to extract easily and quickly the inner ring of the bearings without damages (fig. 1).
Usually extracting the hubs, the rings remain in their seats and without a special tool is not possible to remove them.
This set can be use for the replacement of the rings from Ø 35 to Ø 61 mm.
Critical areas to catch the hold the ring (fig 3. rif. [A] , [B] )
Before proceeding with the tightening of the ring operation it is essential to identify the right holding point (fig. 4 rif. [C] ).
– Ring extraction.
NOTE: adaptor allows to replace the screw included with the mechadraulic one.
[1]
[2]
[3]
[4]
[5]
CLAS Equipements
ZA de la CROUZA
73800 CHIGNIN
FRANCE
Tél. +33 (0)4 79 72 62 22
Fax. +33 (0)4 79 72 52 86
If you need components or parts, please contact the reseller.
In case of problems, please contact your authorized technician.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>